Polar G600 User Manual

3

UK

•

Switch off and disconnect from the power supply before cleaning.

•

Clean the interior of the appliance as often as possible.

•

Do not use abrasive cleaning agents. These can leave harmful residues. 

•

Clean the door seal with water only.

•

Always wipe dry after cleaning.

•

Do not allow water used in cleaning to run through the drain hole into 
the evaporation pan.

•

Take care when cleaning the rear of the appliance. Sharp edges can cut. 

•

A POLAR agent or qualified technician must carry out repairs if required.

Periodically cleaning the condenser can extend the life of the appliance.
POLAR recommend that a POLAR agent or qualified technician clean the 
condenser.

EU regulations require refrigeration product to be disposed of by specialist 
companies who remove or recycle all gasses, metal and plastic components.
Consult your local waste collection authority regarding disposal of your 
appliance. Local authorities are not obliged to dispose of commercial 
refrigeration equipment but may be able to offer advice on how to dispose 
of the equipment locally.
Alternatively call the POLAR helpline for details of national disposal 
companies within the EU.

If your POLAR appliance develops a fault, please check the following table 
before making a call to the Helpline or your POLAR retailer.

The appliance 
is not working

The unit is not switched on

Check the unit is 
plugged in correctly 
and switched on

Plug and lead are damaged

Call POLAR agent or 
qualified Technician

Fuse in the plug has blown

Replace the fuse

Power supply

Check power supply

Internal wiring fault

Call POLAR agent or 
qualified Technician

The appliance 
turns on, but 
the 
temperature is 
too high/low

Too much ice on the condenser Defrost the appliance
Condenser blocked with dust

Call POLAR agent or 
qualified Technician

Doors are not shut properly

Check doors are shut 
and seals are not 
damaged

Appliance is located near a heat 
source or air flow to the 
condenser is being interrupted

Move the refrigerator to 
a more suitable location

Ambient temperature is too 
high

Increase ventilation or 
move appliance to a 
cooler position

Unsuitable foodstuffs are being 
stored in the appliance

Remove any excessive 
hot foodstuffs or 
blockages to the fan

Appliance is overloaded

Reduce the amount of 
food stored in the 
appliance

The appliance 
is leaking water

The appliance is not properly 
levelled

Adjust the screw feet to 
level the appliance (if 
applicable)

The discharge outlet is blocked Clear the discharge 

outlet 

Movement of water to the drain 
is obstructed

Clear the floor of the 
appliance (if applicable)

The water container is 
damaged

Call POLAR agent or 
qualified Technician

The drip tray is full

Empty the drip tray (if 
applicable)

The appliance 
is unusually 
loud

Loose nut/screw

Check and tighten all 
nuts and screws

The appliance has not been 
installed in a level or stable 
position

Check installation 
position and change if 
necessary