Palsonic 6159 User Manual

10

STD         AUTO

BLUE            ON

Making use of the FUNCTION menu can select BLUE ON/OFF and current channel’s colour and
sound system.

SYS                  1

Press CH          button to highlight AUTO. Press VOL          button the set will automatically
search and store the active TV signals in your local area from lower band to higher band in the
sequence of  VL    VH     U  with the green bar moving rightward. When a station is located, the set
will store the signals with a channel number from 0. When all the signals are searched and stored,
the TV returns to 0 channel automatically, auto-search is finished.
* After auto-search, all programs colour  system is set to AUTO and in AFT-ON mode.
* During the process of auto-search, if      , MENU or CH          button is pressed, the searching is
interrupted. Press VOL          button the searching begins again.

Making use of SEARCH function will store a TV program at a referred channel position.

Select a channel number, when SEARCH is highlighted, press VOL          button, the set begins to

search for signals upward or downward from current channel. When a station is located, the

searching stops and the program is stored into the referred channel position.

Repeat the above step and store another program signals into another position. If two channels are

same, the previous will be deleted.

When the searching is finished, to store the program signals you should press the MENU button

to exit the menu and the program signals are stored automatically.

* When the tuning changing reaches the highest (lowest), the searching turns to next band’s lowest

(highest) and continues searching. If the signals are not the signals you desire, you can press the

VOL          button again until the desired signals are searched.

When some program’s picture or sound is not good, you can make use of this function to fine tune

the tuning voltage.

Press VOL           button to highlight MANUAL. Press  VOL          successively, the set begins

searching upward or downward. When the picture has obtained the optimum effect, release the

button.

To store the effect you should press the MENU button to exit the menu and the effect is stored

automatically.