PAC swi-ps User Manual
8
Troubleshooting Guide
Working on a new or unlisted vehicle?
We are always looking for new vehicle information. If you’ve successfully completed the installation on a vehicle with
steering wheel controls, and the vehicle is not listed in these instructions or on our Website, contact us at
techsupport@pac-audio.com so that we may add the information to the instructions.
Pacific Accessory Corporation
1502 S. Santa Fe St. • Santa Ana, CA 92705
techsupport@pac-audio.com • www.pac-audio.com
Copyright 2005 Pacific Accessory Corporation. Content subject to change without notice.
No power / won’t go into programming mode:
• Check
Red wire connection and fuse. Make sure INTERFACE is connected to switched +12volts, not constant +12volts.
• Make sure vehicle ignition is on.
The INTERFACE controls the stereo immediately without pressing any buttons on the steering wheel:
• During programming, press the buttons on the steering wheel firmly until the left LED turns off. Releasing the button too early
will cause the INTERFACE to send out a signal even when no buttons are pressed.
The INTERFACE controls the radio whenever the steering wheel is turned (mostly late 80’s early 90’s Honda/Acura).
• Program the INTERFACE for version #11.
When ever I program a new button the previous button does not work.
• You must program all buttons during programming. If you try to program another button, all previous button will be erased. You
will have to relearn all previous buttons again.