Polycom 7000 User Manual
NetEngine IAD User Guide
Router Configuration
106
Configuring
a Port IP
Address
Address
To configure the IAD as a router, you must assign an IP address to both
the LAN and WAN ports—each with different subnet masks.
the LAN and WAN ports—each with different subnet masks.
To configure an IP address:
1. Type
C
on the Router Configuration menu to select Configure Port IP
address.
2. If more than one WAN port is installed or more than one PVC/DLCI
exists, the IAD displays the interfaces on this IAD (sample shown):
Available Interfaces:
1. SDSL
2. 10/100BaseT Ethernet
0. (Abort)
2. 10/100BaseT Ethernet
0. (Abort)
Type the interface number to configure.
3. The IAD displays the port table for this interface and prompts for a port.
Port VPI VCI Encapsulation Type
PCR
Service
1
0
40 RFC 1483 (with LLC Encap)3641
UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to configure and press Enter.
4. The IAD displays the IP interfaces on the port you’re configuring:
IP interfaces on port 1:
ID
IPAddr
IPMask
Priority
0
91.1.8
255.255.255.0
NORMAL
IP Over Bridge is enabled
Enter the ID of the interface (0-7) to configure and press Enter.
5. The IAD displays the current IP address and prompts for a new one:
Enter new IP address for this interface:
(91.1.1.18) ->
Type the new IP address and press Enter.
6. The IAD displays the current subnet mask and prompts for a new one:
Current subnet mask = 255.255.255.255
Enter new subnet mask for this interface:
Enter new subnet mask for this interface:
(
255.255.255.255) ->
Type the new subnet mask address and press Enter.
7. The IAD prompts you to determine traffic priority on this port:
Select priority Normal/High [N/H] (N):
Do one of the following:
a. Set the interface to high priority—type
a. Set the interface to high priority—type
H
.
b. Set the interface to normal priority—type
N
.
NOTE
You can assign up to 8 IP addresses on each of the WAN
and LAN ports.
and LAN ports.