Polycom 7000 User Manual
NetEngine IAD User Guide
Router Configuration
111
Setting the RIP Version
To set the RIP version:
1. Type
V
on the Router Configuration menu to select Configure RIP
Version by Port.
2. If more than one WAN port is installed or more than one PVC/DLCI
exists, the IAD displays the interfaces on this IAD (sample shown):
Available Interfaces:
1. SDSL
2. 10/100BaseT Ethernet
0. (Abort)
2. 10/100BaseT Ethernet
0. (Abort)
Type the interface number to set.
3. The IAD displays the port table for this interface and prompts for a port:
Port VPI VCI Encapsulation Type
PCR
Service
1
0
40 RFC 1483 (with LLC Encap)3641
UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to set and press Enter.
4. The IAD displays the RIP configuration and status of the slot and port
you’re setting, and prompts for a new version:
Current RIP configuration for Slot 1, Port 1 is
Disabled
Enter RIP Version for Port 1
Disabled
Enter RIP Version for Port 1
0. Disabled
1. Version 1 Broadcast
2. Version 2 Broadcast
3. Version 2 Multicast
1. Version 1 Broadcast
2. Version 2 Broadcast
3. Version 2 Multicast
Type the option number of the version to set.
5. Setting the RIP version for this port is complete. The IAD saves the
settings and displays the Router Configuration menu.
6. Repeat these steps for each remaining port to set.
7. Continue with other configuration tasks, or press Escape to return to
7. Continue with other configuration tasks, or press Escape to return to
the Main menu.
8. Reset the IAD (page
) when you finish router configuration.