Polycom spectralink scd408 User Manual

SpectraLink 6100 MCU: Installation and Operation: SpectraLink 6000 System

PN: 1725-36097-001_J.doc

Replace a Handset

If a handset breaks or needs to be replaced, the old handset must be
deleted and the new handset added.

Delete old handset

1. Make sure all unregistered handsets are off. If this is not done an

unregistered handset may unintentionally register to an available
line.

2. Move the mode switch to the

position on the MCU.

3. Press the

STEP

button until the LED for the line to be deleted is

flashing red.

4. Press the

DEL/ENTER

button.

You can now register a new handset or return the mode switch to the

NORMAL

position.

1. Make sure all unregistered handsets are off.
2. Move the mode switch to the

position.

3. Press the

STEP

button until the desired line to be registered is

flashing red. Only unregistered lines can be registered.

4. Press

PWR

on the handset that needs to be registered. The LED

should change to mostly on once the handset is registered.

5. Wait at least three seconds and then press

END

6. Return the mode switch to the

NORMAL

position.

7. To assign the extension number, hold down the

FCN

key until

Volume

Level

displays. Press the

# >

key until

EXTENSION

displays

on the handset. Press

, then enter the correct extension number.

8. When the handset is turned on, the extension will be displayed.

Test the handset by placing a call to each handset to verify that the
correct handset rings.