Polycom spectralink sca516 User Manual

Connect and Register Handsets

PN: 1725-36097-001_J.doc

—

Initially

Line 2

will flash. This is because

Line 1

is usually set up

as the remote access diagnostic modem. To register a handset
to

Line

, press the

STEP

button until

Line

flashes.

—

If the desired line already has a handset registered to it, follow
the procedure outlined below to unregister the handset, then
return to this step.

4. Turn on the handset to be registered by holding down the

PWR

key until the handset beeps twice. After a few seconds, the line
indicator LED on the MCU will shine solid red. Once the handset
is registered, the LED for the next line begins to flash.

5. To assign the extension number, hold down the

FCN

key until

Volume

Level

displays. Press the

# >

key until

EXTENSION

displays

on the handset. Press

, then enter the correct extension number.

Press

END

when finished.

6. Repeat steps 3 through 5 for all handsets to be registered.
7. When all handsets are registered, return the mode switch to the

NORMAL

position.

Unregister Handsets

If the desired line already has a handset registered to it, follow this
procedure to unregister the handset.
1. Move the mode switch on the MCU to the

position. If

your system has more than one MCU, be sure to move the switch
on the correct MCU. The

LINE

indicator LEDs now show which

lines have handsets registered.

2. Use the

STEP

button to select the line to be unregistered. The

LINE

indicator LED for a line that has a handset registered to it will
flash with the LED mainly on.

3. Press the

DEL/ENTER

button. The

LINE

indicator LED for the selected

line will be off with a short on flash

4. Register the new handset or return the mode switch to the

NORMAL

position.