Plantronics wireless headset system wo100 User Manual

Plantronics Savi User Guide

26

I can’t hear a dial tone at the 
headset.

Make sure your headset is charged.
Make sure your headset is subscribed to base. See 

Subscribing a Master Headset

 on page 15.

Press the call control button on your headset.
Make sure the lifter is lifting the handset high enough to operate the hookswitch; set to a higher 
setting if necessary. 
Adjust the configuration switch on the base until a dial tone is heard. 
Fine tune the listening volume with the call control button. 
If the volume is still too low, adjust the desk phone listening volume on the base.

I hear static.

Make sure there is at least 12 inches between your base and your computer, and 6 inches 
between your base and your telephone. If adjusting the distance doesn’t help, your headset is 
going out of range, move closer to the base. 

The sound is distorted when 
using my Savi Office system with 
my desk phone.

Lower the desk phone speaking volume and/or Desk Phone Listening Volume on the base. For 
most telephones, the correct setting is position 3.
If your desk phone has a volume control, lower until the distortion disappears. 
If the distortion is still present, adjust the headset volume control to lower the headset speaker 
volume.  If the distortion persists, lower the Desk Phone Listening Volume on the base. 
Make sure there is 12 inches between your base and your computer, and 6 inches between your 
base and your telephone. 

I hear echo in the headset when 
using my desk phone.

Adjust the Configuration Switch. The most commonly used position is “A”, which is the default 
position. 
Lower the Desk Phone Listening Volume on the base. For most telephones, the correct setting is 
position 3.
If the audio level is too low in this position, adjust the headset volume control to increase the 
headset speaker volume. 
Lower the Desk Phone Speaking Volume on the base. For most telephones, the correct setting is 
position 3.
If your speaking volume is too low for your listener in this position, adjust the position of the 
headset to make sure the microphone is as close as possible to your mouth. 

People I talk to can hear a buzz 
in the background.

Move the base further away from your phone.
Base power supply is plugged into a power strip. Plug the power supply into the wall directly.

Talk time performance is 
significantly degraded even  
after a full recharge.

Battery is wearing out. Call Plantronics at (800) 544-4660 for factory service information or contact 
us at www.plantronics.com/support.

The handset lifter is installed  
but does not lift the handset.

Be sure the handset lifter power cord is firmly pushed into the handset lifter jack on the base.