Philips 1160xcc User Manual

water while plugged in. For assistance call 1-800-243-3050.

4.  Keep the razor, Jet Clean System, charging stand, cord and 

  charging plug away from heated surfaces.

5.  Never drop or insert any object into any opening.

6.  

Do not clean, charge or plug in razor/Jet Clean System 

outdoors or operate where aerosol (spray) products are being 

used or where oxygen is being administered.

7.  

Do not use this razor with a damaged or broken comb, as 

facial injury may occur.

8.  Always put razor in Jet Clean System/charging stand first,   

  attach cord to Jet Clean System/charging stand, then plug 

  into outlet. Be certain plug is inserted firmly into Jet Clean 

  System/charging stand, up to mark indicated on plug. To  

  disconnect, turn Jet Clean System/charging stand off then   

  remove charging plug from outlet. 

9.  Never put the razor/Jet Clean System/charging stand in direct  

  sunlight or store at a temperature above 140°F.

10. Keep the Jet Clean System, charging stand and cord dry at all   

  times. Do not handle with wet hands. Do not store in a damp  

  environment.

11. To prevent possible damage to the cord, do not wrap cord 

  around the razor or Jet Clean System/charging stand.

IMPORTANT: The power plug contains a transformer. Do not 

cut off the power plug to replace it with another plug, as this will 

cause a hazardous condition.

 

• Only use power plug supplied with the razor. 

• Only use Jet Clean System supplied with the razor.

When using an electric appliance, basic precautions should always 

be followed, including the following:

1.      Do not reach for a corded Jet Clean System/charging stand that 

has fallen into water.  Unplug immediately.

2.      Charging stand is not for immersion or for use in shower.

3.      Do not use an extension cord with this appliance.

4.      Do not place or store a Jet Clean System/charging stand where 

it can fall or be pulled into a tub or sink. Do not place or drop 

a Jet Clean System/charging stand into water or other liquid.

5.    Always unplug this Jet Clean System/charging stand from the 

electrical outlet immediately after use, except when razor is 

(re)charging.

6.    Unplug and remove power supply cord from Jet Clean System/ 

 charging stand before cleaning.

1.   Close supervision is necessary when this razor/Jet Clean System/

charging stand is used by, on, or near children or invalids.

2.   Use this razor/Jet Clean System/charging stand for its intended 

household use as described in this manual. Do not use 

attachments or a cleaning solution not recommended by Philips 

Electronics North America Corporation.

3.     Never operate this razor/Jet Clean System/charging stand if 

it has a damaged cord or charging plug, if it is not working 

properly, if it has been dropped or damaged, or dropped into 

5

4