Philips 4608 User Manual
8.
7
Remove and clean one cutter and head at a time.
•
Be careful not to mix up cutters and heads. They
are a matched set and if interchanged,it will greatly
affect shaving performance.
are a matched set and if interchanged,it will greatly
affect shaving performance.
8
Separate the cutter from the comb.
9
Only brush the cutter in an upward motion.
Use the short bristled side of the brush.
Use the short bristled side of the brush.
10
Brush the slots of the razor head.
For optimum performance, razor cutters and combs
should be cleaned in a degreasing liquid (e.g.Norelco
Razor Cleaner, model RC1776,or alcohol) and lubricated
For optimum performance, razor cutters and combs
should be cleaned in a degreasing liquid (e.g.Norelco
Razor Cleaner, model RC1776,or alcohol) and lubricated
with Norelco Razor Lubricant,model AL80,or one drop of
mineral oil (in the center of the head).
mineral oil (in the center of the head).
11
Replace the cutter and razor head in the Head Assembly.
12
Repeat the process for the other two razor heads
(cutters and combs).
(cutters and combs).
13
Replace the frame.
9.
14
Press down and turn the wheel clockwise until it locks
into place.
into place.
15
Replace the Razor Head Assembly back on razor.
After Each Use:Trimmer
1
Turn razor OFF by locking the switch to the “OFF” position.
2
Push Trimmer Slide Switch up to pop-up Trimmer.
3
Clean Trimmer with the brush every time you use it.
4
Lubricate the Trimmer teeth with Norelco Razor
Lubricant (model AL80),or with one drop of mineral
oil every 6 months.
Lubricant (model AL80),or with one drop of mineral
oil every 6 months.
5
Close Trimmer by sliding Trimmer switch down.