Philips 8160xlcc User Manual

Page of 16
ENGLISH
ENGLISH
5
4
5
4
IMPORTANT SAFETY
INSTRUCTIONS
When using an electric appliance, basic precautions should always
be followed, including the following:
Read all instructions before using this appliance.
DANGER
To reduce the risk of electric shock:
1. Do not reach for a corded razor/Jet Clean System that has fallen
into water. Unplug immediately.
2. Use razor only in dry condition. Do not use a razor/Jet Clean
System while bathing or in a shower.
3. Do not submerge razor in water.
4. Do not place or store a razor or Jet Clean System where it can
fall or be pulled into a tub or sink. Do not place or drop a razor 
or Jet Clean System into water or other liquid.
5. Always unplug this razor/Jet Clean System from the electrical 
outlet immediately after use, except when razor is (re)charging.
6. Unplug and remove power supply cord from razor before 
cleaning.
WARNING
To reduce the risk of burns, fire, electric shock, or injury
to persons:
1. Close supervision is necessary when this razor/Jet Clean
System is used by, on, or near children or invalids.
2. Use this razor/Jet Clean System for its intended household use
as described in this manual. Do not use attachments or a
cleaning solution not recommended by Philips Electronics
North America  Corporation.
3. Never operate this razor/Jet Clean System if it has a damaged
cord or charging plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water while
plugged in. Return the razor/Jet Clean System to the Philips
Norelco Service Location for examination and repair.
4. Keep the razor, Jet Clean System, cord and charging plug away 
from heated surfaces.
5. Never drop or insert any object into any opening.
6. Do not clean, charge or plug in razor/Jet Clean System outdoors 
or operate where aerosol (spray) products are being used or 
where oxygen is being administered.
7. Do not use this razor with a damaged or broken comb, as facial
injury may occur.
8. Always attach plug to razor/Jet Clean System first, then to outlet.
Be certain that plug is inserted firmly into razor/Jet Clean System,
up to mark indicated on plug. For Jet Clean System use, always 
put razor in first, attach cord to Jet Clean System, then plug into
outlet.To disconnect, turn razor/Jet Clean System off then
remove charging plug from outlet.
9. Never put the razor/Jet Clean System in direct sunlight or store 
at a temperature above 140°F.
10. Razor can be rinsed under running tap water. Do not charge or
operate razor corded until fully dried.
11. Keep the Jet Clean System and cord dry at all times. Do not 
handle with wet hands. Do not store in a damp environment.
12. To prevent possible damage to the cord, do not wrap cord 
around the razor or Jet Clean System.
SAVE THESE 
INSTRUCTIONS
IMPORTANT: The power plug contains a transformer. Do not
cut off the power plug to replace it with another plug, as this will
cause a hazardous condition.
CAUTION: Keep cleaning solution out of reach of children. Do
not take internally. Avoid contact with eyes. In case of eye contact,
thoroughly flush with cold water. If irritation persists, get medical
attention.