Philips az1030 User Manual

Page of 13
TROUBLESHOOTING
13
Problem
Possible cause
Solution
No sound, 
VOLUME is not adjusted.
Adjust volume.
no power
Headphones are connected.
Disconnect headphones.
Mains cable is not securely connected.
Connect mains cable properly.
Batteries are flat.
Insert fresh batteries.
Batteries are inserted incorrectly.
Insert batteries correctly.
Trying to change over from mains to 
Remove the mains plug from the 
battery supply without removing the plug.
unit’s AC MAINS socket.
No reaction to 
Electrostatic discharge.
Disconnect the set from power supply, 
operation of any keys
reconnect after a few seconds.
Poor radio reception Weak radio signal.
Direct the antenna for optimum 
reception.
Interference caused by electrical equipment 
Keep the radio away from electrical 
like TVs, computers, engines, etc.
equipment.
no or indication
The CD is badly scratched or dirty.
Replace or clean the CD.
No CD is inserted.
Insert a CD.
The CD is inserted upside down.
Insert CD with label facing up.
The laser lens is steamed up.
Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty.
Replace or clean the CD.
SHUFFLE
or 
PROGRAM
is active.
Switch off 
SHUFFLE
or 
PROGRAM
.
Poor cassette 
Dust and dirt on the heads, capstans or 
Clean heads, capstans, and pressure 
sound quality
pressure rollers.
rollers.
Use of unsuitable cassette types 
Only use NORMAL type cassettes for 
(METAL or CHROME) for recording.
recording.
Recording does 
Cassette tab(s) may be snapped off.
Apply a piece of adhesive tape over
not work
the opening.
English
WARNING
Under no circumstance should you try to
repair the set yourself as this will
invalidate the guarantee.
If a fault occurs, first check the points listed
below before taking the set for repair.
If you are unable to solve a problem by
following these hints, consult your dealer or
service center.
AZ 1030 /00  
page
13
AZ1030/00 eng  6/14/00 10:00 AM  Page 13