Philips AZ 1060 User Manual

10

Switching on and off
1. Adjust the POWER slider to the desired sound source: CD,

TUNER or TAPE/

.

™ The respective function indicator: 

, 

or 

lights up.

2. To switch off, adjust the POWER slider to TAPE/

position

with the keys on the tape deck released.

™ The respective function indicator: 

, 

or 

goes out.

™ The volume and tuner presets will be retained in the set's

memory.

Adjusting volume and sound
1. Turn VOLUME to the desired level.
2. Adjust the DBB control to select dynamic bass boost on or off.

PHILIPS demo mode
1. Press the CD STOP 

9 button for 5 seconds.

™ After about 30 seconds, PH..IL ..IPS scrolls across the display.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts

the demo mode for 30 seconds;

• press the CD STOP 

9 button for 5 seconds. PH..IL ..IPS

scrolls once before the demo mode is cancelled.

• Do not expose the set, batteries, CDs or cassettes to humidity,

rain, sand or excessive heat caused by heating equipment or
direct sunlight.

• To clean the set, use a soft, slightly dampened chamois

leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.

• Place the set on a hard and flat surface so that the system

does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.

• The mechanical parts of the set contain self-lubricating

bearings and must not be oiled or lubricated.

AZ 1060 /17  

page

10

TUNER

DYNAM

IC BASS

 BOOST

CD

TAPE

TUNER

DYNAM

IC BASS

 BOOST

CD

TAPE

XP AZ 1060/17  30-11-2000 11:06  Pagina 10