Philips az1120-11h User Manual
TROUBLESHOOTING
11
AZ 1120 /00
page
11
English
PROBLEM
– POSSIBLE CAUSE
• REMEDY
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME is not adjusted
• Adjust the VOLUME
– VOLUME is not adjusted
• Adjust the VOLUME
– Headphones connected
• Disconnect headphones
• Disconnect headphones
– Mains lead not securely connected
• Connect AC mains lead properly
• Connect AC mains lead properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
• Insert (fresh) batteries correctly
Display does not function properly/ No
reaction to operation of any of the controls
– Electrostatic discharge
• Switch off set, disconnect the mains plug
reaction to operation of any of the controls
– Electrostatic discharge
• Switch off set, disconnect the mains plug
and reconnect after a few seconds
CD playback does not work
– CD is badly scratched/ dirty
• Replace/ clean CD (see maintenance)
– CD is badly scratched/ dirty
• Replace/ clean CD (see maintenance)
– Laser lens steamed up
• Wait until lens has acclimatized
• Wait until lens has acclimatized
The CD skips tracks
– CD is damaged or dirty
• Replace or clean the CD
– CD is damaged or dirty
• Replace or clean the CD
– SHUFFLE or PROGRAM is active
• Quit SHUFFLE/PROGRAM mode(s)
• Quit SHUFFLE/PROGRAM mode(s)
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see Maintenance
– Use of incompatible cassette types (METAL
or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space
Remote control does not function properly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Batteries exhausted/ incorrectly inserted
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle
• Reduce the distance/ angle
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
This product complies with the radio interference requirements
of the European Community
The type plate is located on the bottom of the set.
XP AZ 1120/00-1 22-06-2000 15:08 Pagina 11