Philips az156017 User Manual

Whenever convenient, use the AC power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall outlet before inserting batteries.

1. Open the battery compartment and insert six batteries, type 

R-20, UM-4 or D-cells, (preferably alkaline) with the correct
polarity as indicated by the "+" and "-" symbols inside the
compartment.

2. Replace the compartment door, making sure the batteries are

firmly and correctly in place. The set is now ready to operate.

– If BATT LOW lights up, battery power is running low.

– The BATT LOW indicator eventually goes out if the

batteries are too weak.

– Do not mix battery types, e.g. alkaline with carbon zinc.

Only use batteries of the same type for the set.

– When inserting new batteries, do not try to mix old

batteries with the new ones.

– Remove the batteries if the set is not to be used for a long

time.

– Batteries contain chemical substances, so they

1. Check if the mains voltage as shown on the type plate

located on the bottom of the set, corresponds to your local
AC power supply. If it does not, consult your dealer or service
center.

2. If your set is equipped with a voltage selector, adjust the

selector so that it matches with the local power.

3. Connect the power cord to the wall outlet and the set is now

ready for use.

4. To disconnect the set from the power completely, remove the

plug from the wall outlet.

9

AZ 1560/ 17  

page

9

XP AZ 1560/17  19-09-2000 13:06  Pagina 9