Philips az2010 User Manual

English

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair. If you are
unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING:

Do not open the set as there is a risk of electric shock. Under no circumstances
should you try to repair the set yourself, as this would invalidate the guarantee

PROBLEM

– POSSIBLE CAUSE

• REMEDY

No sound/power

– VOLUME is not adjusted

• Adjust the VOLUME

– Headphones are connected

• Disconnect headphones

– Mains lead not securely connected

• Connect the AC mains lead properly

– Batteries exhausted/ incorrectly inserted

• Insert fresh batteries/ batteries correctly

CD playback sounds distorted at maximum
level

– Original CD pre-recorded at very high sound

level

• Reduce volume and/or deactivate any added

sound features e.g. bass control

Display does not function properly/ No
reaction to operation of any of the controls

– Electrostatic discharge

• Switch off set, disconnect the mains plug

and reconnect after a few seconds

CD playback does not work

– CD is badly scratched or dirty.

• Replace or clean the CD, see Maintenance.

– Laser lens steamed up

• Wait until lens has acclimatized

The CD skips tracks

– CD is damaged or dirty.

• Replace or clean the CD

– SHUFFLE or a programme is active.

• Quit SHUFFLE/PROGRAM mode(s)

Poor cassette sound quality

– Dust and dirt on the heads, etc.

• Clean deck parts etc., see Maintenance

– Use of incompatible cassette types (METAL

or CHROME)

• Only use NORMAL (IEC I) for recording

Recording does not work

– Cassette tab(s) may be broken out

• Apply a piece of adhesive tape over the

missing tab space

This product complies with the radio interference requirements

of the European Community

The type plate is located on the bottom of the set.