Philips bienvenido cd440 User Manual
Frequently asked questions
29
8
Frequently asked
questions
questions
In this chapter you will find the most frequently
asked questions and answers about your phone.
asked questions and answers about your phone.
Connection
The handset does not switch on!
•
•
Charge the battery : Put the handset on
charger. After a few moments the phone will
switch on.
charger. After a few moments the phone will
switch on.
•
Check the charger connections
•
Use only the SUPPLIED
RECHARGEABLE BATTERIES
RECHARGEABLE BATTERIES
The phone does not work at all.
•
•
Make sure that the adaptor and the phone
cord are connected properly
cord are connected properly
•
Check that the batteries are fully charged
and installed properly
and installed properly
•
This phone does not work during power
failure
failure
Communication is lost during a call!
•
•
Charge the battery
•
Move closer to the base station
Poor audio quality
•
•
Move closer to the base station
•
Move the base station at least one metre
away from any electrical appliances
away from any electrical appliances
No dialling tone
•
•
Check the connections. Reset the phone :
unplug and plug back in the mains.
unplug and plug back in the mains.
•
Charge the batteries for at least 24 hours
•
Move closer to the base station
•
Use the line cable provided
•
Connect the line adaptor (when needed) to
the line cord
the line cord
The is
blinking.
•
Move closer to the base station
•
Check battery level
•
Register the handset to the base station
The
appears soon after the batteries
are charged.
•
•
Replace the batteries with new ones (use
only RECHARGEABLE batteries)
only RECHARGEABLE batteries)
Set-up
Caller ID does not work properly.
•
•
Check with your local phone company that
the CID service is subscribed to
the CID service is subscribed to
•
Let the phone ring at least once before
answering
answering
The Call Waiting call cannot be answered.
•
•
Check with your local phone company and
select the correct recall duration
select the correct recall duration
The handset LCD displays nothing.
•
•
Try again by disconnecting and connecting
the base station power supply and follow
the procedure to register a handset (see
Section 5.7.6)
the base station power supply and follow
the procedure to register a handset (see
Section 5.7.6)
•
Make sure the two supplied rechargeable
batteries have been inserted properly into
the battery compartment
batteries have been inserted properly into
the battery compartment
•
Remove and place back the handset
batteries
batteries
•
Make sure the supplied batteries are
charged up
charged up
The handset displays UNREGISTERED
•
•
Follow the procedures to register the
handset to a base
handset to a base