Philips dtr1500 User Manual

SAFETY INSTRUCTIONS 3

All the safety and operating Instructions

should be read and understood before the

receiver is operated.
For best results, position your receiver

away from radiators or other heat sources.

Leave a space of at least 3 cm around the

receiver for ventilation making sure that the

ventilation holes are not obstructed.
This receiver is intended for use in a

domestic environment only and should

never be operated or stored in excessively

hot, humid or damp conditions.
Make sure no objects or fluids enter the

housing through the ventilation slots. Should

this happen, disconnect your receiver from

the mains and consult your retailer.
For cleaning, use a damp chamois leather.

Never use any abrasive cloth, sponge or

cleaner.
When connecting or disconnecting cables to

the receiver always ensure the receiver is

disconnected from the mains.
Please wait before connecting your receiver

- read on.
Do not disassemble the equipment. There

are no user serviceable parts.

Mains connection
Before connecting the receiver to the

mains, check that the mains supply voltage

corresponds to the voltage printed on the

rear of the receiver. If the mains voltage is

different, consult your dealer.

Important:

This apparatus is fitted with an approved

moulded BBSS11336633 plug.

To change a fuse in this type of plug proceed as

follows:

1. Remove fuse cover and fuse.

2. Fit new 3A fuse that should be a BS1362

ASTA approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your

socket outlets, it should be cut off and the

appropriate plug fitted in its place. If the

mains plug contains a fuse, this should have

a value of 3A.

If a plug without a fuse is used, the fuse at

the distribution board should not be greater

than 5A.

Note: The severed plug must be destroyed to

avoid a possible shock hazard, should it be

inserted into an appropriate socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured in

accordance with the following code:

- BLUE - NEUTRAL (N)

- BROWN - LIVE (L)

The BLUE wire must be connected to the

terminal, which is marked with the letter

N or coloured BLACK.

The BROWN wire must be connected to

the terminal, which is marked with the

letter L or coloured RED.

Do not connect either wires to the earth

terminal in the plug that is marked by the

letter E or by the safety earth symbol or

coloured green or green-and-yellow. Before

replacing the plug cover, make certain that

the cord grip is clamped over the sheath of

the lead - not simply over the two wires.

Please wait before connecting your

receiver - read on.

1 Safety instructions

English