Philips ftr9965-69s User Manual

20

Clean the TV with a slightly damp soft cloth. Do not use abrasive solvent as it can 
damage the TV screen.

• Have you selected the correct TV system in the manual installation menu? 
• Is your monitor or house aerial located too close to loudspeakers, non-earthed 

audio equipment or neon lights, etc.?

• Mountains or high buildings can cause double pictures or ghost images.

Sometimes you can improve the picture quality by changing the direction of the 
aerial.

• Is the picture or teletext unrecognisable? Check if you have entered the correct 

frequency. See Installation, p. 6.

• Are brightness, sharpness and contrast out of adjustment? Select Factory 

settings in the Setup, General menu, p. 8.

• Are the supplied cables connected properly ? (The aerial cable to the receiver 

box, the other aerial to your recorder, the VGA cables to the display, the power 
cables.)

• Has the child lock been switched off ?
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the monitor lights up 

green, this means that the display mode is not supported. Switch your
VGA-source to a correct mode.

• In case of weak or bad signal, consult your dealer.

The low quality of some digital picture material may be the cause of digital image 
distortion. In this case select the Soft setting using the Picture menu, Smart Picture,
without changing the picture settings manually.

• No sound on any channel? Check the volume isn’t at minimum.
• Is the sound interrupted with the mute key ¬? 

•  Check if the headphone is not plugged in.

• Perhaps the channel is not broadcasting good quality surround sound.
• No sound from the rear speakers or the centre speakers? Select an appropriate 

surround mode, according to the broadcasted sound signal or adjust the 
volume. See Surround Modes, p. 11.

Switch your TV off and then on again once. Never attempt to repair a defective   

TV yourself. Check with your dealer or call a TV technician.

Have you selected the wrong menu?  Press the 

key again to exit from the 

menu.

• Check if the remote control is in the correct mode.
• If your TV no longer responds to the remote control, the batteries may be dead.
• You can still use the 

key and the -/+ keys at the top of your TV.

Your TV consumes energy in the standby mode. Energy consumption contributes 
to air and water pollution.

Check if you have selected the correct VGA mode in your PC. See the separate

instruction manual with the monitor.

In case you connect your TV receiver box with a speakerless monitor, and 

without having connected an audio receiver, all references made in this 

r                    instruction book to sound reproduction, volume control, and audio connections,

are not applicable (except for a headphone connection).
The keys on the remote control referring to sound have no function either.

. Ambient temperature: + 5~ + 40°C

. Mains: 50/60 Hz Auto Voltage ranging from 95 V to 264 V
. Power consumption: around 35 W
. Standby consumption: 2 W
.Weight (excl. packaging): 4 kg
. Dimensions (wxhxd): Receiver: 43.5 x 10.5 x 33 cm

1033.1 en  29-04-2003  19:32  Pagina 20