Philips fw-c200-21m User Manual

English

3139 115 20143

To enable the demonstration mode

¶ Press and hold Ç (on the system only) for 5

seconds when the system is in standby mode.

➜ The demonstration will begin.

Notes:
– If the demonstration mode has not been disabled,
it will resume 5 seconds later after the system
switches to standby mode.
– When the system is switched on from the main
power outlet, the CD changer tray may open and
close again to initialize the set.
– Even though the AC power cord is removed from
and reconnected to the wall socket, the
demonstration will remain off until it is switched on
again.

Switching the system ON

¶ Press CD, TUNER, TAPE or AUX.

¶ Press STANDBY-ON in demo.

You can also switch on the system by pressing
any one of the CD DIRECT PLAY buttons (on
system only).

Switching the system to standby
mode

¶ Press STANDBY-ON or B on the remote

control.
➜ The system will switch to standby mode.

Selecting the Source

¶ Press the respective source selection button: CD,

TUNER, TAPE or AUX.

➜ The display indicates the selected source.

Note:
– For an external source, make sure you have
connected the audio left and right OUT terminals
of the external equipment (TV, VCR, Laser Disc
player, DVD player or CD Recorder) to the AUX IN
terminals.

DIM mode

You can select the desired brightness for the
display.

¶ Press DIM to select DIM 1, DIM 2, DIM 3 or

DIM OFF display mode.
➜ The

DIM

display lights up.

➜ "DIM 1", "DIM 2", "DIM 3" or "DIM OFF"
will be displayed depending on the mode
selected.

DIM OFF - normal brightness with
Spectrum Analyzer On

DIM 1 - normal brightness with Spectrum
Analyzer Off

DIM 2 - half brightness with Spectrum
Analyzer On

DIM 3 - half brightness with Spectrum
Analyzer Off and all LEDs on the system
will be switched off.

Operating the System

pg 01-28/C200/21-Eng

29/05/2001, 10:13 AM