Philips hd7448-70 User Manual

Page of 15
ENGLISH
Important
.
Read these instructions for use carefully before using the appliance and save them for
future reference.
Check if the voltage indicated on the appliance corresponds to the local mains
voltage before you connect the appliance.
Do not use the appliance if the mains cord, the plug or the appliance itself is
damaged.
If the mains cord is damaged, it must be replaced by Philips, a service centre
authorised by Philips or similarly qualified persons in order to avoid a hazard.
Do not place the appliance on a hot surface and prevent the mains cord from
coming into contact with hot surfaces.
Keep the appliance and its cord out of the reach of children. Do not let the
mains cord hang over the edge of the table or worktop on which the
appliance is standing.
Never immerse the appliance in water or any other liquid.
Unplug the appliance before cleaning it and if problems occur during brewing.
Preparing for use
.
1
Clean the jug and the filter holder (see chapter 'Cleaning').
2
Put the appliance on a flat and stable surface.
3
Put the plug in an earthed wall socket.
You can store excess cord by pushing it into the opening at the back of the
coffee maker (fig. 1).
Prevent the cord from coming into contact with hot surfaces.
Flushing the appliance
1
Open the lid (fig. 2).
2
Fill the water tank with cold fresh water and put the jug in place (fig. 3).
Do not put a filter and ground coffee in the filter holder.
3
Switch the appliance on by pressing the on/off switch (fig. 4).
The light goes on (HD7448 only).
Let the appliance run until the water tank is completely empty.
4
Switch the appliance off when all the water is in the jug.
5
Let the appliance cool down for at least 3 minutes before you start brewing coffee.
Using the appliance
.
Brewing coffee
1
Open the lid (fig. 2).
2
Fill the water tank fresh cold with water (fig. 5).
The graduations on the left are for large cups (120 ml).
The graduations on the right are for small cups (80 ml).
3
Close the lid.
4
Place the jug on the hotplate.
Make sure you place the jug properly on the hotplate.
B
If you don't place the jug properly on the hotplate, the drip stop will prevent the
coffee from flowing into the jug and the filter may overflow as a result.
5
Open the filter holder (fig. 6).
6
Take a paper filter (type 1x4 or no. 4) and fold the sealed edges to prevent
tearing and folding.
In some countries this coffee maker comes with a permanent filter. In that case you
should not use paper filters.
7
Put the filter in the filter holder.
8
Put pre-ground coffee (filter-fine grind) in the filter (fig. 7).
For large cups: use one heaped measuring spoon of ground coffee for each cup.
For small cups: use one level measuring spoon of ground coffee for each cup.
9
Close the lid.
10
Switch the appliance on by pressing the on/off switch (fig. 4).
The light goes on (HD7448 only).
11
When all the water has passed through the filter, you can remove the jug
from the appliance.
12
Switch the appliance off after use.
13
Let the appliance cool down for at least 3 minutes before you start brewing
coffee again.
14
Remove the filter holder and throw the paper filter away.
15
If you have used the permanent filter, empty and rinse it.
Cleaning
.
Always unplug the appliance before you start cleaning it.
Never immerse the appliance in water.
1
Clean the outside of the appliance with a moist cloth.
2
Detach the filter holder.
3
Clean the jug and the removable filter holder in hot water with some washing-
up liquid or in the dishwasher (fig. 8).
4
After cleaning, rinse the jug with fresh hot water.
Descaling
.
Regular descaling will prolong the life of the appliance and will guarantee optimal
brewing results for a long time.
In case of normal use (two full jugs of coffee every day), descale the coffee maker:
- 2 or 3 times a year if you are using soft water;
- 4 or 5 times a year if you are using hard water.
Turn to your local water board for information about the water hardness in your area.
1
Fill the water tank with white vinegar. Do not put a filter and ground coffee in
the filter holder.
2
Let the appliance complete two brewing cycles.
See chapter 'Using the appliance'. Let the appliance cool down before you start the second run.
3
Let the appliance complete two more brewing cycles with fresh, cold water to
remove all vinegar residues.
You can also use an appropriate liquid descaler. In this case, follow the
instructions on the package of the descaler.
Do not use a descaling powder.
4
Clean the separate parts (see chapter 'Cleaning').
Accessories
.
You can order a new jug from your Philips dealer or a Philips service centre
under type number HD7983/70 (white) or HD7983/20 (black).
You can order a permanent filter from your Philips dealer or a Philips service
centre under reference number 4822 48050 479 (permanent nylon coffee filter).
Environment
.
Do not throw the appliance away with the normal household waste at the end
of its life, but hand it in at an official collection point for recycling. By doing
this you will help to preserve the environment (fig. 9).
Guarantee & service
.
If you need information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Customer Care Centre in your country (you
will find its phone number in the worldwide guarantee leaflet). If there is no
Customer Care Centre in your country, turn to your local Philips dealer or contact
the Service Department of Philips Domestic Appliances and Personal Care BV.
422200199351
8/15