Philips lx7500r-01 User Manual
WARNING
Under no circumstances should you try to repair the set yourself as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock.
In case you need any support,
1) check the points listed below,
2) visit http://www.philips.com/support for online support,
3) call our help line (see page 63).
1) check the points listed below,
2) visit http://www.philips.com/support for online support,
3) call our help line (see page 63).
Laser safety
This unit employs a laser. Only a qualified service person should remove
the cover or attempt to service this device, due to possible eye injury.
the cover or attempt to service this device, due to possible eye injury.
Problem
Solution
No power
– Make sure the mains cable is connected properly.
– Press 2 STANDBY•ON on the set to switch it on.
– Press 2 STANDBY•ON on the set to switch it on.
No reaction to controls and
–
IS TV ON? indication
The set is in initial installation mode: Switch the TV on and continue as
described in the chapter “Initial installation” on page 17.
described in the chapter “Initial installation” on page 17.
No reaction to controls
– Check the power supply.
– Disconnect the set from power supply, reconnect after 30 seconds.
– Reset the set to the default factory settings: All the information stored
– Disconnect the set from power supply, reconnect after 30 seconds.
– Reset the set to the default factory settings: All the information stored
(programmes, time and date) will be lost.
1
Disconnect the set from power supply.
2
Press and hold down 2 STANDBY•ON on the set and reconnect the
set.
set.
3
Release 2 STANDBY•ON after 5 seconds.
4
Continue as described in chapter “Initial installation”.
Set does not work
– The DVD recorder system has become too hot and the overheating safety
and is in standby
circuit has been activated. Let the DVD recorder system cool down, then
press 2 STANDBY•ON on the set to switch it on again.
press 2 STANDBY•ON on the set to switch it on again.
Remote control does not function
– Point the remote control towards the set.
properly
– Remove batteries, wait 10 seconds and insert them correctly or insert new
batteries.
– Reduce distance to the set.
– The remote control has been switched to control external equipment.
– The remote control has been switched to control external equipment.
Briefly press DVD/MON or TUNER to control the DVD recorder or the
radio tuner.
radio tuner.
Cannot switch on/off the system menu
– Press DVD/MON. Next, press SYSTEM MENU.
Demo mode is on
– Select w Features
➜
Standby. in the system menu. Select the setting Low
power or Normal. See page 48.
External equipment not selectable
– The selected equipment is not installed on the DVD recorder system.
and
SOURCE NOT AVILABLE is scrolled
Please see “Input settings” on page 54 on how to perform installation.
Troubleshooting
58
English