Philips mz-1100 User Manual
23
English
3139 115 21642
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you
are unable to solve a problem by following these hints, consult your dealer or service centre.
are unable to solve a problem by following these hints, consult your dealer or service centre.
Troubleshooting
The disc is ejected automatically.
Radio reception is poor.
The system does not react when buttons are
pressed.
Sound cannot be heard or is of poor quality.
The left and right sound outputs are reversed.
The remote control does not function
properly.
The timer is not working.
✔
Load in the disc with label facing right.
✔
Replace or clean the disc, see “Maintenance”.
✔
Use a finalised CD-RW or a correct MP3-CD format
disc.
✔
If the signal is too weak, adjust the antenna or connect
an external antenna for better reception.
✔
Increase the distance between the system and your TV
or VCR.
✔
Remove and reconnect the AC power plug and switch
on the system again.
✔
Adjust the volume.
✔
Disconnect the headphones.
✔
Check that the speakers are connected correctly.
✔
Make sure the MP3-CD was recorded within 32-256
kbps bit rate with sampling frequencies at 48 kHz,
44.1 kHz or 32 kHz.
✔
Check the speaker connections and location.
✔
Select the source (MP3-CD or TUNER, for example)
before pressing the function button (É,
S , T).
✔
Reduce the distance between the remote control and
the system.
✔
Replace the battery.
✔
Point the remote control directly toward the IR sensor.
✔
Set the clock correctly.
✔
Press and hold CLK/TIMER to switch on the timer.
Problem
Solution