Philips sbcru970 User Manual

4 Place the battery cover back on.

Note

Make sure the cable of the battery pack does not get stuck between the
mould and the battery cover.

After a few seconds, the Remote Control starts up automatically and an
Introduction screen appears. The Remote Control beeps twice to indicate that
it has finished starting up.  

Because the battery pack of the Remote Control is not fully pre-charged, you
will have to charge it as described below.

For charging the Remote Control you use the docking station.

1 Plug the power adapter into a wall outlet and connect it to the docking

station.

2 Place the Remote Control in the docking station. 

Make sure you hold the Remote 
Control at an angle of 30° to 45°
when you place the it in the 
docking station.

Charging starts immediately. The green charging LED on the front of the
docking station indicates charging takes place. When the Remote Control is
fully charged, the LED goes off.

Note

Normal charging time is 2 to 3 hours, depending on the condition of the
battery pack. 
You can operate the Remote Control while it is being charged.
The battery pack does not have to be entirely empty before recharging. 
You can place the Remote Control in the docking station at any time. 

When the battery pack is running low, the Low Battery icon 

flashes on the

Remote Control icon 

. Recharge the Remote Control as soon as possible to

ensure perfect performance.

Note

The Remote Control retains all settings when the battery pack has run out. 
You will only have to set the clock. See “Adjusting the Settings” on page 18.