Philips VR1010 User Manual

— 14 —

Total Page Number

AIN

EATURES

TAPE MANAGER

INTRODUCTION

The Philips Tape Manager is a very
helpful and powerful assistant.
The Tape Manager will tell you;
- on which tape you find your recorded

programmes.

- on which tape you find enough blank

space for new recordings.

Every recording will be memorised
(date, start and stop time, length and
channel) and the tapes will be given
unique numbers to identify them.

Find a Title

This function is useful when you wish to
quickly find out what programmes you
have recorded on a tape using this VCR.
It allows you to select a programme to
watch, and then automatically searches
for the start of the programme.

Load a Recorded Cassette

Insert a recorded cassette. The tape will
run for a few seconds to search for the
tape number. The tape number is
displayed on the screen for about 5
seconds.

Access Title Screen

1 Press

VCR.

2 Press

TAPE MANAGER

. The title

screen will appear.

Note:
• If no cassette is inserted in the VCR,

“FIND TITLE” screen appears. (✈P.15)

Select a Programme

1 Press

PLAY

5 or

STOP

∞ to select

the programme
you want to watch.

2 Press

OK/STATUS

. Playback begins

automatically after the selected
programme is located. Press

STOP

7 if you wish to stop the tape at the
beginning of the programme.

Notes:
• It may take a few seconds to display the

directory screen while the VCR searches
for the programme information at step 2.

• Tape manager is possible with the

cassettes recorded with this VCR only.

• To record the date and time as the

programme title in this VCR’s memory,
make sure the VCR’s clock is set correctly
before recording.

• To record the programme information in

this VCR’s memory, you must record each
programme for over the minimum
continuous recording time;
-For PAL signal: 8 minutes for the SP
mode or 15 minutes for the LP mode.
-For NTSC signal: 5 minutes for the SP
mode or 15 minutes for the SLP mode.

• After recording a tape with this VCR,

write the tape number on a label and affix
the label to the tape in order to allow you
to find the tape by its number. The tape
number will be assigned and appear on
the screen once you eject the recorded
tape.

• If the Tape Manager does not show the

content of the inserted tape, wind the tape
to a recent recording and press the TAPE
MANAGER button again.

• The programme information is stored in

this VCR’s memory. If the memory in this
VCR should ever be damaged and the
programme information lost, it is
impossible to restore that information.

• If the VCR finds two tape numbers in one

tape while playing back or searching for
the beginning of a program, then when
you remove the tape, the tape will be
assigned just one number (smaller
number).

How To Read the Tape Manager Screen

The following information appears on the Tape Manager screen described above.

Current Inserted

Tape Number

Tape Title

Start date
of record

Start time
of record

“*” mark is
displayed at
the current
tape position

The largest blank space on the tape

Record Channel
Number

Detail data of the programme pointed by
the cursor; recording start and stop time/
Total record time/tape speed/Programme
Title/Category

Current Displayed

Page Number

CA0013 FOOTBALL 1/ 3
BLANK 1:25 (SP)
10:00PM 26/02/00 CH 30
08:00PM 27/02/00 CH 10

09:00PM 13/02/00 CH 25

10:15PM 28/02/00 CH 56

09:00P 10:30P 1:30 (LP)

WORLD CUP /SPORTS

SELECT : CONFIRM : OK
END : TAPE MANAGER