Philips vr720 User Manual
40
VIDEO PLUS+
PLUSCODE NUMBER
REP.
53124----
èONCE
p
________________________________
REP.pSELECT
REP.pSELECT
STOREpOK
TIMER LISTpTIMER
Selecting onetime/daily/weekly recordings
Using
SELECT
, select from the following options:
'ONCE': Recording once
'MO-FR': Repeated daily recordings (Monday to Friday)
'WEEK.': Repeated weekly recordings (every week on the same day)
'MO-FR': Repeated daily recordings (Monday to Friday)
'WEEK.': Repeated weekly recordings (every week on the same day)
4
Confirm with OK .
TIMER
VPS
DATE
REP.
PROG. START PDC END
21
MO-FR
01
20:00
]
21:30
________________________________
REP.pSELECT
REP.pSELECT
STOREpOK
aThe following message appears on the screen: 'SELECT PROG.
NR.'
b The programme number of the TV channel has not yet been assigned to
the PlusCode Deluxe number. Using the number buttons
0-9
on the
remote control, select the corresponding programme number (name) of the
TV channel and confirm with
TV channel and confirm with
OK
.
b If you are using a 'IR satellite control' and you want to enter a satellite
programme number, press
SELECT
. Make sure that your IR satellite
control has been connected properly (see chapter 'IR satellite control').
Enter the satellite programme number for the TV channel you want to
programme using the number buttons
Enter the satellite programme number for the TV channel you want to
programme using the number buttons
0-9
on the remote control.
aThe following message appears on the screen: 'PLUSCODE NUMBER
NOT VALID'
b The entered PlusCode Deluxe number is incorrect. Correct your
instructions or end with
MENU
.
b Check the time/date (see chapter 'Installing your video', section 'Setting the
time and date').
aThe following message appears on the screen: 'MO-FR
PROGRAMMING NOT POSSIBLE FOR WEEKEND'
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
5
The decoded data appears after confirmation. You can go back to
change the data. Select the corresponding input field using P or
change the data. Select the corresponding input field using P or
Q . Change the data with ;qP , P r= or with the number
buttons 0-9 .
Switching on 'VPS/PDC' in the 'START' input field
Select the 'START' input field using
P
. Using
SELECT
switch on
'VPS/PDC' (']' lights up). If you press
SELECT
again, you will switch
'VPS/PDC' off (']' goes out).
Attention: If you have programmed a TV channel from the satellite receiver,
you cannot use 'VPS/PDC' for this programme number.
Attention: If you have programmed a TV channel from the satellite receiver,
you cannot use 'VPS/PDC' for this programme number.
6
When all informations are correctly, confirm with
OK . The
programming information is stored in a TIMER block.
7
Insert a cassette with an intact security tab (unprotected).
Programming a recording (TIMER)