Pfaff smart 200c User Manual

14

Attention: Turn power switch to off (“O”) when 
carrying out any of the operations below.

Change the needle regularly, especially if it is 
showing signs of wear and causing problems.

Insert the needle following the illustrated 
instructions.

A.  Loosen the needle clamp screw and tighten   

again after inserting the new needle.

 The 

fl at side of the shaft should be towards the  

back.

B.  Insert the needle as far up as it will go. 

Needles must be in perfect condition. Problems 
can occur with:

- Bent 

needles

- Blunt 

needles

- Damaged 

points

Attention: Turn power switch to off 
(“O”) when carrying out any of the 
operations below.

Raise the presser foot bar (a). Attach the 
presser foot holder (b) as illustrated.

Lower the presser foot holder (b) until the 
cut-out (c) is directly above the pin on the 
foot (d).

Raise the lever (e).

Lower the presser foot holder (b) and the 
presser foot (f) will engage automatically.

Raise the presser foot.

Raise the lever (e) and the foot will 
disengage.

Attach the seam guide (g) in the slot as 
illustrated. Adjust according to need for 
hems, pleats, quilting, etc.