Pelco DX7008-240 User Manual
Pelco Manual C682M-E (11/01)
7
INSTALLATION
Place the DVR on any flat surface (desk or table) or install in any standard 19-inch (48.26 cm)
wide console or rack configuration.
wide console or rack configuration.
Figure 1. Rear View of Back Panel
1
Camera Inputs –
Refer to Table A for video coaxial cable distances.
2
Alarm Inputs
3
Analog Monitor Output
4
Relay Outputs
5
PC Monitor Output
6
LAN Port
(Internet or TCP/IP)
7
NTSC/PAL Selection Switches –
Setting must correspond with the software
setup for NTSC/PAL. Refer to Figure 6, item
2
.
8
Joystick Port
(Not used)
9
Microphone Jack
(Not used)
10
Audio IN/OUT
(Not used)
11
COM 2 Serial Port –
Connection for optional external modem.
12
Printer Port
13
COM 1 Serial Port –
RS-422 two-wire control output; refer to Figure 2.
14
USB Connection –
For optional USB device (CD-RW).
15
Keyboard
(PS/2)
16
Mouse
(PS/2)
17
AC Power Output
18
115/230 VAC Power Switch
19
AC Power Input
Table A. Video Coaxial Cable Requirements
Cable Type*
Maximum Distance
RG59/U
750 ft (229 m)
RG6/U
1,000 ft (305 m)
RG11/U
1,500 ft (457 m)
* Minimum cable requirements:
75 ohms impedance
All-copper center conductor
All-copper braided shield with 95% braid coverage
All-copper center conductor
All-copper braided shield with 95% braid coverage
00589
NOTE:
Set the PAL/NTSC
Switch to the proper setting
for your application. Refer to
for your application. Refer to
7
.
NOTE:
An UPS (Uninter-
rupted Power Supply) is not
supplied with the DVR.
If required, Pelco recom-
mends a device with the
following specifications:
supplied with the DVR.
If required, Pelco recom-
mends a device with the
following specifications:
Capacity –
350 VA, 210 watts
Output voltage –
115 V
350 VA, 210 watts
Output voltage –
115 V
±
8% (on battery)
Frequency range –
47 Hz to 63 Hz
47 Hz to 63 Hz