Pelco bk4000-bk4024 User Manual
PELCO Manual C430M-E (1/95)
7
4.2 HEATER KIT INSTALLATION
Refer to Section 2.4, Recommended Cable Size, to de-
termine cable size needed for installation. To install the
heater and/or blower kits perform the following steps
(refer to Figure 2):
termine cable size needed for installation. To install the
heater and/or blower kits perform the following steps
(refer to Figure 2):
1.
Remove the Phillips head screws from the rear cap
and slide the assembly out from the enclosure.
and slide the assembly out from the enclosure.
2.
Attach the bracket with the terminal strip and heater
thermostat to the rear plate using two (2) 6-32 self-
tapping screws, mount onto the drilled-out holes.
thermostat to the rear plate using two (2) 6-32 self-
tapping screws, mount onto the drilled-out holes.
3.
Install the bracket with the heater pad onto the front
of the sled using the 1/4-20 screw.
of the sled using the 1/4-20 screw.
4.
Wire according to the wiring diagram in Figure 3.
Figure 2. Heater Bracket and Blower Installation
4.3 BLOWER KIT INSTALLATION
To install the BK4000/BK4024, perform the following
steps:
steps:
1.
Remove the Phillips Head screws from the rear cap
and slide the assembly out from the enclosure.
and slide the assembly out from the enclosure.
2.
Attach the blower assembly to the rear plate using
two of the self-tapping screws holding the end cap
to the sled.
two of the self-tapping screws holding the end cap
to the sled.
3.
Wire according to the wiring diagram in Figure 3.
NOTE: When used in conjunction with a
heater kit, the blower can be wired into the ter-
minal block on the P.C. Board.
heater kit, the blower can be wired into the ter-
minal block on the P.C. Board.