Pelco EM1400 User Manual

Prior to installation and use of this product, the following WARNINGS should be observed.

1.

Installation and servicing should only be done by qualified service and installation personnel.

2.

Installation shall be done in accordance with all local and national electrical and mechani-
cal codes utilizing only approved materials.

3.

Use only installation methods and materials capable of supporting four times the maxi-
mum specified load.

4.

Use stainless steel hardware to fasten the mount to outdoor surfaces.

5.

To prevent damage from water leakage when installing a mount outdoors on a roof or
wall, apply sealant around the bolt holes between the mount and mounting surface.

The product and/or manual may bear the following marks:

Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.

3500 Pelco Way,
Clovis, CA 93612-5699
USA

In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150

International Customers:
Tel (1-559) 292-1981
FAX (1-559) 348-1120

This symbol indicates that there are important operating and maintenance instruc-
tions in the literature accompanying this unit.

Pelco’s Model EM1400 Light Duty Wall Mount has been engineered for use with EH4010/
EH4014/EH4018 enclosures and light-to medium-weight cameras. It is designed for mounting
on any wall or vertical surface and is capable of supporting loads up to 20 pounds (9 kg).

The EM1400 has an adjustable head which allows mechanical positioning of the camera/
enclosure.

To install the EM1400 enclosure mount, perform the following steps.

1.

Drill holes in mounting surface using the mount as a template, and attach the mount se-
curely with fasteners of minimum 1/4-inch diameter (not supplied).

If you install the mount outdoors, rain water could leak through the holes for the mounting
bolts and damage the wall.

To prevent water damage, seal the bolt holes with an appropriate sealant. Apply the seal-
ant around the bolt holes between the mount and the mounting surface.

2.

Attach the enclosure or camera securely with the two 1/4-20 hex head screws provided.

3.

Loosen the hex head bolts on the swivel head and adjust for pan rotation (360

°

) and tilt

angle (75

°

 up or down). Tighten bolts and lock into place.

Two hex head machine

screws for mounting the enclosure/
camera are supplied. Fasteners
to secure the mount to the de-
sired mounting surface are not
supplied.

 Make cer-

tain that the mounting
surface is able to sup-

port the full load of the mount,
enclosure, and camera.