Seventeam ST-300P-AE Leaflet

ST-300P-AE

INPUT CHARACTERISTICS:

VOLTAGE: 100

VAC ~ 240

VAC

FULL RANGE(WITH

±10% TOLERANCE)

FREQUENCY: 50

~60

INPUT CURRENT: 6.3

A (RMS)

INRUSH CURRENT: 100

A MAX

SPECIFICATION:

  EFFICIENCY: 70% TYPICAL, FULL LOAD CONDITION AT 115/230 VAC INPUT.
  POWER GOOD SIGNAL: ON DELAY TIME 100 ~ 500 ms, OFF DELAY TIME 1ms.
  HOLD UP TIME: 16ms AT 25℃  FULL LOAD CONDITION AT 115/230 VAC INPUT.
  OPERATING TEMPERATURE RANGE: 5℃ ~ 50℃.
  REMOTE ON/OFF CONTROL: THE POWER SUPPLY OUTPUT SHALL BE ENABLED WITH AN

ACTIVE-LOW TTL SIGNAL. WHEN TTL SIGNAL IS LOW, THE DC OUTPUTS ARE TO BE ENABLED.
WHEN TTL SIGNAL IS HIGH OR OPEN CIRCUITED, THE DC OUTPUTS ARE TO BE DISABLED.

OVER POWER PROTECTION: AT 115/230 VAC INPUT THE POWER SUPPLY WILL SHUT DOWN

ALL DC OUTPUT WITHIN 120% TO 160% OF FULL LOAD.

  OVER VOLTAGE PROTECTION: +5V  → 7.5V, +12V → 16.5V, +3.3V → 4.8V
  EMI REQUIREMENT: FCC PART 15 SUB PART J CLASS B AT SYSTEM LOAD, CISPR 22 CLASS B.
  SAFETY: UL.CUL.TUV.CB
  DIMENSION: 150 (D) x 140 (W) x 86 (H) mm.
  COOLING: ONE 80mm DC FAN.
  ACTIVE POWER FACTOR CORRECTION: EN 61000-3-2: 1995+A1+A2: 1998, CLASS D.

OUTPUT CHARACTERISTICS:

OUTPUT CURRENT

REGULATION

OUTPUT

VOLTAGE

MIN

[A]

MAX

[A]

LOAD

LINE

RIPPLE

MAX

[P-P]

NOISE

MAX

[P-P]

+3.3V

1.0

±5%

±1%

50mV

+5V

1.0

±5%

±1%

50mV

+12V1

1.0

±5%

±1%

120mV

+12V2

1.0

±5%

±1%

120mV

-12V

0.5

±10%

±1%

120mV

120Mv

-5V

0.3

±10%

±1%

50mV

+5VSB

2.5

±5%

±1%

70mV

1. MAXIMUM CONTINUOUS COMBINED LOAD ON +5V AND +3.3V OUTPUTS SHALL NOT EXCEED 130W.

2. MAXIMUM CONTINUOUS COMBINED LOAD ON +12V1, +12V2, OUTPUTS SHALL NOT EXCEED 216W

3. MAXIMUM CONTINUOUS TOTAL DC OUTPUT POWER SHALL NOT EXCEED 300W.

Ver. 0.1