Garmin gpsmap 192c User Manual

A

PPENDIX

 > 

M

OUNTING

 

THE

 GPSMAP 192C U

NIT

1.  Cut a 4.33

"

 x 4.33

"

 (110 x 110 mm) hole in the panel.

2.  Place the GPSMAP 192C into the hole from the front until 

the flange rests against the mounting surface.

3.  From the back of the panel, loosely attach the bracket so 

the slot in the ratchet area points away from the mounting 

panel (figure 1).

4.  Rotate the bracket downward until the panel is pinched 

tightly between the unit’s flange and bracket lobe (figure 1).

5.  Tighten the knobs and connect the power/data and antenna 

cables. 

The GPSMAP 192C, with external antenna, can be flush mounted 

on a flat panel using its existing mounting bracket.

1.  Remove the four M5 screws from the back of the unit and 

remove the mounting bracket.

2.  Using the mounting bracket as a template, outline the 

center relief area and mark the location of the four screw 

holes centers on your bulkhead or other surface (figure 2).

3.  Cut the relief hole from the panel and drill the four 0.20" 

(5.08 mm) screw holes.

4.  Place the GPSMAP 192C into the relief hole until it rests 

flush against the mounting surface.

5.  Secure the unit to the mounting surface using the M5 

screws. Do not try to force the screws deeper into the holes 

than the holes allow. For thick mounting surfaces, insert 

the M5 screws directly thru the drilled holes (figure 3). For 

thin panels, place the mounting bracket on the back side 

of the panel for more support. Connect the power/data and 

antenna cables.