ONKYO dr-2000 User Manual

48

The high frequency/high quantization sound signals below are
converted into 48 kHz/16 bit sound signals and sent to the
speakers when the “Audio Out Select” (sound signal
conversion method) is set to the standard setting, “Bitstream.”

High frequency/high quantization signals
• 48 kHz/24 bit
• 96 kHz/16 bit
• 96 kHz/20 bit
• 96 kHz/24 bit

To listen to the high-frequency (kHz)/hight-quantization (bit)
format sounds in their original sound quality, follow the steps
below.

See 

a

 in the table titled “Sound from the

speakers” on the opposite page.
The DVD videos recorded in 48 kHz/24 bit,
96 kHz/16 bit, 96 kHz/20 bit, and 96 kHz/
24 bit are reproduced through the
speakers at the same kHz and bit rate
respectively.

See “Setting the Subwoofer Mode” on
page 19.

See “Changing the Sound to Stereo” on
page 38.

See previous
page.

• The “Audio Out Select” setting in the setting menu (see page 56) is

for  automatic selection of the sound conversion method when the
disc is inserted. Therefore, the selection in this section will not
change the setting of “Audio Out Select” in the setting menu.

• When you turn on the DVD Receiver or replace a disc, the DVD

Receiver returns to the automatic setting in the setting menu. (See
page 56.)

The reproduced disc sound will be output in the most suitable format
automatically through the connected speakers and output connector/jacks
on the DVD Receiver when “Audio Out Select” in the setting menu is set to
“Bitstream” (see page 56).
However, you may need to convert the sound format in different ways
depending on your purpose and preference.

For example, when you wish to:
• Listen to the high-frequency (kHz)/high-quantization (bit) format source

in its original sound quality (see below), or

• Record the DVD video sound reproduced in the DOLBY DIGITAL format

using recording equipment such as an MD recorder connected to the
DIGITAL OUTPUT (OPT) connector on the DVD Receiver (see next
page).

Audio:

Audio OUT Select : Bitstream

ENG PCM

2CH

1

Audio:

Audio OUT Select : 96k Sound

ENG PCM

2CH

1

The current audio setting is displayed for
about 3 seconds.

Each time you press  / , the setting
changes as follows:

 Bitstream 

↔

 96k Sound 

↔

 PCM

↑

↑

For details about “Bitstream,” “96k Sound,”
and “PCM,” see the explanation on page
56 and the table on the opposite page.

The current sound signal
conversion method

CLEAR

AUDIO

/

If the speakers were setup using Smart Configuration (see page 17),
the subwoofer data such as characteristic frequency will be erased by
the above steps. To recover the data, carry out the Smart
Configuration setup again.

Remote controller

only