Multi-Tech Systems MT5600BA-V92 User Manual
Chapter 3 – Using the Front Panel
Multi-Tech Systems, Inc. MT5600BA-V92 User Guide
27
Remote Configuration Options
The following LCDs are used to configure remote configuration options. For more information about
remote configuration, see Chapter 5, “Remote Configuration.”
remote configuration, see Chapter 5, “Remote Configuration.”
ENABLE/DISABLE R.C
Use the Æ and Enter buttons to turn remote configuration on or off.
REMOTE CONFIG. PASSWORD
Use to enter the remote configuration password. To scroll through a list of digits and
characters, press the Ç Å and È buttons. To go to the next position, press the Æ button.
To back up or to exit without saving, press the Æ button several times. To save the
password, press the Enter button.
characters, press the Ç Å and È buttons. To go to the next position, press the Æ button.
To back up or to exit without saving, press the Æ button several times. To save the
password, press the Enter button.
Diagnostic Options
Use the following LCDs to turn loopback tests on and off.
ANALOG LOOPBACK
Press the Æ and Enter buttons to start the analog loopback test. The TEST IN
PROGRESS
PROGRESS
LCD appears. To stop the test, press the Æ and Enter buttons again.
DIGITAL LOOPBACK
Press the Æ and Enter buttons to start the local digital loopback test. The TEST IN
PROGRESS
PROGRESS
LCD appears. To stop the test, press the Æ and Enter buttons again. Same
as the &T3 command.
REMOTE DIGITAL LOOPBACK
Press the Æ and Enter buttons to start the remote digital loopback test. The TEST IN
PROGRESS
PROGRESS
LCD appears. To stop the test, press the Æ and Enter buttons again. Same
as the &T6 command.
Note:
Digital Loopback and Remote Digital Loopback tests must be performed using AT
Commands. The LCD option to run these tests has been temporarily removed.
Phone Number Memory Options
Use the following LCDs to list, enter, and dial stored phone numbers. Up to four phone numbers can
be stored. The number in memory location 0 is used for DTR dialing, if DTR dialing is enabled.
be stored. The number in memory location 0 is used for DTR dialing, if DTR dialing is enabled.
Note:
Only 16 characters can be displayed at a time. To display characters 17–30, press the È
button. To go to the previous LCD, press the Å button. To go to the next LCD, press the Æ button.
LIST PHONE NUMBERS
Press the Æ button several times to display the phone number stored in each memory
location.
location.
ENTER PHONE NUMBERS
Use to store up to four phone numbers in memory locations 0–3. Each number can have up
to 30 characters. To scroll through a list of digits and characters, press the Ç Å and È
buttons. To go to the next position, press the Æ button. To back up or to exit without
saving, press the Æ button several times. To save the number, press the Enter button.
Same as the &Z= commands.
to 30 characters. To scroll through a list of digits and characters, press the Ç Å and È
buttons. To go to the next position, press the Æ button. To back up or to exit without
saving, press the Æ button several times. To save the number, press the Enter button.
Same as the &Z= commands.
DIAL STORED NUMBERS
Press the Æ and Enter buttons to dial a stored phone number. Same as the DS=
commands.
commands.