Linear AE-100 User Manual

23

AFTER AN INCORRECT ENTRY

TWO
LONG 
BEEPS

ONE
LONG
BEEP

AFTER A CORRECT ENTRY OF AN 
INTERIM STEP

ONE
SHORT 
BEEP

TWO 
SHORT 
BEEPS

AFTER A COMPLETE COMMAND 
HAS BEEN ENTERED CORRECTLY

TWO 
SHORT 
BEEPS

THREE 
SHORT 
BEEPS

EXITING PROGRAMMING MODE

THREE 
SHORT 
BEEPS

NO
BEEPS 
SOUND

Q Z - , . ' * 

q z 0 1 2 3 

4 5 6 7 8 9

A B C a b c

D E F d e f

space

G H I h g i

P R S p r s

M N O m n o

W X Y w x y

J K L j k l

T U V t u v

erase

entire entry

move to
next letter
or finish

• ENTER # AFTER EACH LETTER TO MOVE TO THE NEXT CHARACTER

• FINISH COMPLETE ENTRY BY ENTERING ##

• PRESS 8 THEN 0 TO BACKSPACE

• PRESS STAR TO ERASE ENTIRE ENTRY

Alternate Programming Section

To make it easy for installers familiar with Linear’s and other manufacturer’s 
access control systems, two methods of programming are available. 
Function Codes that match other equipment help the installer to make 
quick programming changes with keystrokes they have used before.

The Programming Position Numbers (or Function Codes) change 
depending on the programming method used. Refer to the table on 
Page 13 for the numbers used for each programming method.
The keys used to enter programming from the unit’s keypad select 
which programming method is used for the current programming 
session.
Entering programming by pressing 

  & 

  keys together will select 

the Alternate Programming Method (other manufacturer’s style). Details 
of each programming step when using the Alternate Programming 
Method are shown on Pages 23-31.

The audio prompts that give feedback during programming at the unit’s 
keypad or over the telephone are different for the Alternate Programming 
Method. Those differences are shown in the table to the right.

When the keypad is used for alphanumeric data entry in the alternate 
programming mode, each key enters data differently than the standard 
interface mode. See the keypad fi gure to the right.

1. Press   &   keys at the same time, then release.

2.  The display will show [Master Code:].
3.  Enter the master code (factory setting is 123456).
4.  The display will show asterisks as the code is entered.
5.  If the master code is incorrect, the system will sound two 

long beeps and return to normal operating mode.

6.  If the password is correct, the display will 

show [SELECT FUNCTION:].

7.  Programming commands can now be entered on the 

keypad. Refer to the following pages in this manual 
for Alternate Programming Method step details.

If an incorrect entry, or an incorrect key is pressed during programming, to 
clear the keypad press   and start the programming step over again.

1. Press:   

 

✦  NOTE:  The AE-100 will automatically exit Programming Mode after