Linear AE-100 User Manual

8

Entry System Mounting (Continued)

The cabinet can be mounted recessed using the accessory trim-ring 
Model TR-100 (P/N ACP00941). The trim-ring mounts in the wall and the 
cabinet attaches to the trim-ring.

1.  Identify the location of any studs in the wall.
✦ CAUTION!: Watch out for wiring inside the wall.
2.  Determine and mark the 12” high by 10” wide hole location.
3.  Cut the rectangular hole between studs at the mounting location.
4.  Install any additional mounting shims required to provide 

surfaces inside the wall 10” apart for attaching the trim-ring.

5.  Place the trim-ring in the wall hole. Check for level, then 

attach the trim-ring with four screws into the side tabs (the 
tabs can bend out a little to meet the shims if necessary).

6.  Remove the four nuts and bolts that connect the cabinet’s gray 

outer wrap to the cabinet. Remove the outer wrap piece.

7. Drill 

3/16” holes in the cabinet’s six pre-marked locations.

✦ CAUTION!: After drilling, remove any metal chips from the 

8.  The trim ring is supplied with four adhesive mylar stickers. 

Apply these stickers to the cabinet’s four bolt holes that were 
used to mount the outer wrap to the cabinet. The stickers will 
help to seal the cabinet sides from moisture and insects.

9.  Route the wiring through the trim-ring and into 

the cabinet through the center wiring hole.

10.  Attach the cabinet to the trim-ring using 

self-tapping screws supplied.

MARK HOLE LOCATION

INSTALL ANY SHIMS TO
ALLOW MOUNTING AND 
ATTACH THE TRIM-RING
WITH 4 SCREWS

REMOVE THE FOUR
OUTER WRAP BOLTS
AND REMOVE THE
CABINET'S OUTER WRAP 

DETERMINE LOCATION FOR
THE 10" x 12" MOUNTING HOLE

CUT MOUNTING HOLE

APPLY THE FOUR MYLAR
STICKERS TO THE
BOLT HOLES

ATTACH THE CABINET TO
THE TRIM-RING WITH
SELF-TAPING SCREWS

DRILL 3/16" HOLES IN
THE CABINET AT THE
PRE-MARKED LOCATIONS

OUTER WRAP

STICKERS