Casio DQ-950 User Manual

3

Pressing the 

 button (1) turns on the light and illuminates the display for easy reading in the dark.

• Overuse of the light can shorten battery life.

A built-in sensor measures temperature and shows the measured value on the display. The readout from the
temperature sensor can also be switched between Celsius (

°C) and Fahrenheit (°F).

• The temperature display shows “LO” for temperatures below –50°C (–58°F) and “HI” for temperatures above

70

°C (158°F).

• Though temperature readings are displayed up to 0°C (32°F) and greater than 41°C (105°F), note that such

readings are actually outside the guaranteed temperature range of this clock.

• Push the 

°

°

 button  (4) to select either Celsius (

°C) or Fahrenheit (°F).

°

°

 (4)

°C

°F

°

°

• The clock remembers the high and low temperatures it measured since the last time its temperature memories

were cleared. You can recall these values as shown below.

Current temperature and humidity

7

High temperature and low temperature

• To clear the high temperature and low temperature memory, press the 

 button (7) to display the

current high/low values, and then press the 

button (6). Note that the current high/low values are

displayed for only about five seconds, and you need to press the 

button (6) during that period.

New data starts to be stored after memory is cleared.

6

A built-in sensor measures humidity and shows the measured value on the display.

• The humidity display shows “LO” for humidity below 10% and “HI” for humidity above 90%.

• The clock remembers the high and low humidity values it measured since the last time its humidity memories

were cleared. You can recall these values as shown below.

Current temperature and humidity

9

High humidity and low humidity

• To clear the high humidity and low humidity memory, press the 

 button (9) to display the

current high/low values, and then press the 

button (6). Note that the current high/low values are

displayed for only about five seconds, and you need to press the 

button (6) during that period.

6

Replace batteries whenever the display of the clock becomes dim and difficult to read.
1. Open the battery compartment cover as shown in the illustration.
2. Remove all of the old batteries.
3. Load a full set of new batteries. Make sure that their positive (+) and negative (–) ends face in the correct

directions. If you load batteries incorrectly, they can burst and damage the clock.

4. Press the 

button (8). Be sure to press the 

button (8) after replacing batteries.

5. Replace the battery compartment cover.

• Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician

immediately.

• Be sure to load the batteries with their positive (+) and negative (–) ends facing correctly.

• Never mix old and new batteries, or batteries of different brands.

• Never charge the batteries that come with the clock.

• Should batteries ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get onto

your skin.

• Replace the batteries at least once a year, even if the current batteries are working properly.

• The batteries that come with the clock lose some of their power during transport and storage.