Hypercom 1101 User Manual

Trap Definitions

94

Hypercom Corporation

The following variables are provided in order to use SNMP to configure SNTP:

Switched to Alternate Host (7)

(trapSwitchedToAlternate)

Issued when switching to alternate IP 
address due to loss of keep alive or loss of 
TCP session when in permanent TCP 
mode

Invalid Terminal Message (8)

(trapInvalidTerminalMessage)

Issued when an improperly formatted 
message is received from a terminal

Terminal Poll Lost (9)

(trapTerminalPollLost)

Issued when a transition from receiving 
responses to SDLC poll to no response is 
detected

Terminal Poll Restored (10)

(trapTerminalPollRestored)

Issued when a transition from no poll 
response to receiving a poll response is 
detected

Admin Logged In (11)

(trapAdminLoggedIn)

Issued whenever anyone logs in to the 
IN-tact 1101 using the “admin” User ID 
and password

Admin Logged Out (12)

(trapAdminLoggedOut)

Issued whenever “admin” logs out of the 
IN-tact 1101

Admin Password Changed (13)

(trapAdminPasswordChanged)

Issued whenever the password for the 
User ID “admin” is changed

Session Timed Out (14)

(trapSessionTimedOut)

Issued when the five-minute timer expires 
during a session. The session is closed 
and the user is logged out

Maximum Failed Login Attempts 
(15)

(trapMaxFiledLoginAttempts)

Issued whenever the three consecutive 
failed attempts were made to log in to the 
IN-tact 1101

System Error (99)

(trapSystemError)

Issued when the device detects an 
unexpected condition. A four-digit code 
within the trap identifies the unexpected 
condition. Refer to the Error Code table.

SntpStatus

Read-write variable with two choices: enabled and disabled.

TimeZone

Read-write variable. Refer to the Time Zone Table for SNMP  
fto determine the numerical identifier of the time zone you 
wish to set.

PrimaryNTPServerFromDHCP

Read-only variable. Displays the primary NTP server 
assigned by DHCP, if any.

AlternateNTPServerFromDHCP

Read-only variable. Displays the alternate NTP server 
assigned by DHCP, if any.

NtpServersSearchOrder

Read-write variable with two choices: dhcpFirst and 
staticFirst.

StaticPrimaryNTPServer

Read-write variable. IP address or name of static primary 
NTP server.