Morphy Richards ib40713 User Manual

4

Components of your
iron

⁄ Variable steam button
¤ Shot of steam button
‹ Spray button
› Filling hole with cap
fi Spray nozzle
fl Soleplate
‡ Temperature console
· Water tank
‚ Life long anti-scale (certain models only)
„ Filling beaker
‰ Auto shut-off indicator

Before use

Note: The steam facility should only be

used on garments which are suitable for
ironing at the 2, 3 dot settings.

When ironing with the steam facility at

the 2 dot setting, the steam output should
be set at the lower end of the steam range
(see variable steam section).

Textiles and clothes are supposed to

carry ironing instructions. If they don’t you
should follow the fabric guide on page 3,
but be sure to test the temperature by
ironing the hem of the garment or similar
area first.

If you adjust the temperature from a hot

setting to a cooler setting, wait until the iron
temperature has stabilised before you
continue ironing.

It is always a good idea to begin with

cool fabrics and work up to higher settings.

An iron heats up quicker than it cools

down so you’ll save time and electricity.

Filling

1 Make sure that the iron is not plugged in

and then set the variable steam control
⁄ to the ‘0’ position before filling the
iron with water.

2 Lift up the fill cap and fill the water

through the filling hole 

› into the water

tank 

·, using the beaker provided. A

1 beaker fills the tank (400ml). After
filling replace the fill cap. In hard water
areas the use of distilled or
demineralised water is recommended.
WARNING: Never use battery

topping up fluid or water containing
any substances like starch, or sugar,
or defrosted water from a
refridgerator.
3 Always pour out the remaining water

after use.
WARNING: When filling your iron

⁄

¤ ‹

›

fi

fl

‡

·

‚

„

A

‰

40715 Rev 1  31/5/05  9:11 AM  Page 4