Microtek gnc m vx2 0506 User Manual

You may control this projector through the infrared (IR) receiver located at the front

of the projector. However, the projector may not respond to the commands of the

remote control if:

The surrounding light is too bright,

Certain types of the fluorescent lighting are used,

The IR receiver is shined on with a bright light,

Equipment that emits infrared energy such as a radiation heater in the

room.

The above conditions occur frequently for most infrared controlled equipment. 

Try the following solutions:

Replace with new batteries; the batteries may be low on power.

Turn off some of the light sources and remove the projector from direct

sunlight.

Close the window or remove the projector from direct sunlight.

Switch off other equipment that emit infrared energy. 

If any of the conditions above is present, the projector can be controlled via keys

on the control panels of the projector. 

The laser pointer feature in the remote control will emits high energy. Do not look

into it directly or the red beam will injure your eyes seriously. Do not let children

play with the remote control.

The briefing functions offered by the remote control are as follows:

Press the FREEZE key on the remote control to still the image that is

being displayed. The OSD menu will display the FREEZE icon.

Press the DIGITAL ZOOM key on the remote control to enlarge a certain

part of the displayed image form the Computer input or the Video input.

Adjust the four direction keys on the remote control or on the operational

panel to adjust the position of the displayed image. The OSD menu will

display the DIGITAL ZOOM icon.

ＶＸ２．ｐ６５

02-10-18, 11:05

29