Clifford 562C User Manual

2004 Directed Electronics, Inc.

QUICK REFERENCE GUIDE:

To lock using your remote

■ To arm the system press

for one second. The doors will lock (if con-

nected). The LED will begin to flash. The Failsafe

Starter Kill will pre-

vent the vehicle’s starter from cranking if it has been installed. The ve-
hicle’s horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.

To unlock using your remote

■ To disarm the system press

for one second. The doors will unlock (if

connected). The Failsafe

Starter Kill will

be deactivated and the vehicle’s horn (if connected) will honk twice and
the parking lights will flash twice.

Disabling the Failsafe

Starter Kill without a transmitter

■ Turn on the ignition. Press and release the Valet

switch within 10 sec-

onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet

switch.

To remote start the vehicle

■ Press

twice within 3 seconds. The parking lights will turn on (if con-

nected) and the vehicle will start and run for the programmed amount
of time.

To enter or exit Valet

Mode

■ Turn the ignition to the "ON" position. Turn the ignition back off. Press

and release the Valet

switch within 10 seconds. The status LED will

light steadily if you have entered Valet

Mode. To exit Valet

Mode,

repeat the steps above. The LED will turn off when exiting Valet

Mode.

To activate Panic Mode

■ Press and hold

for 1.5 seconds.

To disable the remote start system

■ To disable the remote start, move the shutdown toggle switch to the OFF

position.

Location of Shutdown Switch______________________________

Cut along dotted line and f

old f

or a quick and eas

efer

ence to k

eep in y

our pur

se or w

allet.

✂