Clarion DXZ465MP User Manual

English

DXZ465MP 

Replace with a fuse of the same amperage. 

If the fuse blows again, consult your store of 

purchase.
Consult your store of purchase.

Power does not turn on. 

(No sound is produced)

No sound output when 

operating the unit with

amplifiers or power 

antenna attached.

Fuse is blown.

Incorrect wiring.
Power antenna lead is 

shorted to ground or 

excessive current is 

required for remote-on 

the amplifiers or power 

antenna.

Nothing happens when 

button are pressed.

Display is not accurate.

No sound heard.

The microprocessor has 

malfunctioned due to 

noise, etc.

DCP or main unit 

connectors are dirty.
The speaker protection 

circuit is operating.

1.  Turn the unit off.

2.  Remove  all  wires  attached  to  the  power 

antenna lead. Check each wire for a possible 

short to ground using an ohm meter.

3.  Turn the unit back on.

4.  Reconnect  each  amplifier  remote  wire  to 

the  power  antenna  lead  one  by  one.  If 

the amplifiers turn off before all wires are 

attached, use an external relay to provide 

remote-on  voltage  (excessive  current 

required).

Turn off the power, then press the [

OPEN] 

button and remove the DCP.

Press the reset button for about 2 seconds 

with a thin rod.

Wipe the dirt off with a soft cloth moistened 

with cleaning alcohol.

1.  Turn  down  sound  volume.  Function  can 

also be restored by turning the power off 

and on again. (Speaker volume is reduced 

automatically when the speaker protection 

circuit operates).

2.  If  the  sound  is  muted  again,  consult  our 

service department.