Mackie fussion3000 User Manual

6

This is a female XLR-type connector that

accepts a balanced line-level signal from
your mixing console or signal processor.

This is a male XLR-type connector that

produces exactly the same signal that is
connected to the 

MAIN IN jack. Use it to

daisy-chain several FUSSION 3000s to-
gether off the same signal source.

With the switch set to 

FULL RANGE posi-

tion, the FUSSION 3000 operates from
55Hz to 20kHz. With the switch set to
HIGH PASS, a high-pass filter is placed in
the signal path and the FUSSION 3000 op-
erates from 85Hz to 20kHz. Use this setting
when you have a FUSSION 1800AS con-
nected to the 

SUB OUT connector.

Note: The 

LOOP OUT is not affected by

this switch. It is always full-range, and the
FILL OUT is always 85Hz to 20kHz.

This male XLR-type connector produces

a line-level signal that you can connect to
the FUSSION 1800AS powered subwoofer
system. The FUSSION 3000 has a built-in
controller that operates below 85 Hz.

This is a male XLR-type connector that

produces a line-level signal you can connect
to a side or front fill powered speaker or
speaker amplifier.

Note: The 

FILL OUT has a low-pass filter

that operates from 85Hz to 20kHz, regard-
less of the 

FULL RANGE/HIGH PASS switch

setting.

This controls the output signal level at the

FILL OUT. This control ranges from off up to
unity gain. Use it to adjust the relative vol-
ume for the side or front fill speaker.

This switch reverses the phase of the sig-

nal at the 

FILL OUT connector. Depending

on the placement of the fill speaker, you
may get better overall response with the
PHASE switch set to 180º.

The FUSSION 3000 has a female XLR

input that accepts a balanced or unbalanced
line-level signal. When connecting a balanced
signal, be sure it’s wired per AES (Audio
Engineering Society) standards:

Hot (+)

Pin 2

Cold (–)

Pin 3

Shield (Ground)

Pin 1

There are also three male XLR connec-

tors labeled 

LOOP OUT, SUB OUT, and FILL

OUT. These are also wired according to the
above AES standard.

The 

LOOP OUT connector allows you to

connect more than one FUSSION 3000 to
the output of your mixing console. Simply
plug the signal source output into the first
MAIN IN jack, and patch that speaker’s
LOOP OUT jack to the next MAIN IN jack,
and so on, daisy-chaining multiple speakers.

There is a limit to how
many you can daisy-chain
together. A general rule is
to maintain a load imped-
ance 10 times or more

than the source impedance to prevent ex-
cessive loading on the source. For example,
if your mixer has an output impedance of
120 ohms, then you can daisy chain up to
sixteen FUSSION 3000s. This is a load of
1250 ohms (FUSSION 3000 input
impedance=20k ohms; 16 of these in par-
allel=1250 ohms).

The 

LOOP OUT jack is wired straight

from the 

MAIN IN connector — there is no

electronic circuitry between — so the signal
coming out of the 

LOOP OUT jack is exactly

the same as the signal going in.