ONKYO dv-sp503e User Manual

Page of 68
11
Before Using the DV-SP503E
Notes:
• The supplied batteries should last for about six 
months, although this will vary with usage.
• If the remote controller doesn’t work reliably, try 
replacing both batteries.
• Don’t mix new and old batteries, or different types of 
batteries.
• If you intend not to use the remote controller for a long 
time, remove the batteries to prevent possible leakage 
and corrosion.
• Flat batteries should be removed as soon as possible to 
prevent possible leakage and corrosion.
To use the remote controller, point it at the DV-SP503E’s 
remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the 
DV-SP503E is subjected to bright light, such as direct 
sunlight or inverter-type fluorescent lights. Keep this 
in mind when installing the DV-SP503E.
• If another remote controller of the same type is used in 
the same room, or the DV-SP503E is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the 
DV-SP503E is installed in a rack behind colored glass 
doors. Keep this in mind when installing the DV-
SP503E.
• The remote controller will not work if there’s an obsta-
cle between it and the DV-SP503E’s remote control 
sensor.
Installing the Batteries
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in 
accordance with the polarity diagram 
inside the battery compartment.
3
Close the battery compartment.
Using the Remote Controller
RETURN
SETUP
TOP MEN
U
MENU
CURSOR
P
U
SH
TO ENTER
DV-SP503E
SUPER AU
DIO CD & D
VD AUDIO
 / VIDEO PLA
YER
PROG
RESSIV
E SCA
N
PROGRES
SIVE
30˚
30˚
Appro
x.
 16 ft.
 (5 m)
Remote control sensor
DV-SP503E