GE wwa5400s User Manual

Page of 20
 PROBLEM 
(continued)
PROBLEM
POSSIBLE CAUSE
WATER LEAKS
● 
Make sure hose connections are 
 at faucets.
● 
Make sure end of drain hose is correctly inserted in and secured to drain facility.
WASHER IS NOISY
 Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
● 
A sharp, distinctive 
 will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in.” This sound is normal.
● 
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its 
 position. In extreme cases (usually occurs
when washing a single, heavy 
 or a small load when water level is set higher than
necessary), the spin basket 
 strike the outer tub, creating a loud but harmless noise.
To correct, stop 
 washer by pushing in the Cycle Selector knob, open the lid and
redistribute the load 
 about the wash basket. Close the lid and restart.
I
WASHER PAUSES
● 
Washer normally pauses between washing 
 as between wash and spin or
IN 
between spin and rinse.
If you 
need more 
 toll free: 
GE 
Answer Center” / 
800.626.2000 / 
consumer information service
CARE 
 
USER MAINTENANCE INSTRUCTIONS
The Tub. 
The porcelain is self-cleaning. Leave lid
To Store Washer. 
Ask service technician to remove
open after washing to allow moisture to evaporate.
water from drain pump and hoses to prevent freezing.
Do not use harsh or gritty cleansers.
Do not store the washer where it will be exposed
The Exterior.  Wipe off any spills of washing
to the weather.
compounds. Wipe or dust with damp cloth. Try
For Long Vacations. 
Be sure water supply is shut off
not to hit surface with sharp objects.
at faucets and drain all water from hoses if weather
will be below freezing.
How to remove the agitator
To remove limestone from 
 pan
To remove the agitator,
snap the cap off and remove
the screw. Then remove
the agitator extender (on
models so equipped)
 the agitator.
To replace the agitator,
carefully lower it straight
down onto the shaft so
that it fits snugly into
place. Replace the agitator
extender (on models so
equipped), the screw
and the cap.
— 
Cap
● 
Soak filter pan in a preheated 
 (71 ‘C.)
Screw
solution of half vinegar and half water for 15
Agitator
minutes. Then brush each side of pan with a stiff
Extender
bristle brush while flushing with running water.
(on some models)
— Agitator
CAUTIONS:
● 
Do not soak 
in porcelain container. Vinegar
can damage porcelain.
● 
Do not exceed 
 
 ) or filter pan
— 
may warp.
(Appearance 
may vary)
18