ICOM IC F110S User Manual
6
2
OPERATION
■Turning power ON
q Push [
] to turn the power ON.
w If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your Dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are same.
e When all channel indicator LEDs still blink after inputting 4
digits, the input code number is incorrect. Turn the power
off and start over in this case.
off and start over in this case.
■Channel selection
Several types of channel selection are available. The meth-
ods may differ according to your system setup.
ods may differ according to your system setup.
NON-BANK TYPE:
Push [CH UP]/[CH DN] to select the desired operating chan-
nel, in sequence; or, push one of the [CH 1] to [CH 4] keys to
select a channel directly.
Push [CH UP]/[CH DN] to select the desired operating chan-
nel, in sequence; or, push one of the [CH 1] to [CH 4] keys to
select a channel directly.
BANK-TYPE:
Push [BANK] to toggle between bank 1 and 2.
Push [BANK] to toggle between bank 1 and 2.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the
microphone off hook.
KEY
NUMBER
0
1
2
3
4
5
6
7
8
9
IC-F110_210S_EUR-2.qxd 05.9.16 10:32 AM Page 6 (1,1)