Oricom bb200 User Manual

Page of 16
 
 
- 6 - 
 
 
INSTALLATION
 
 
POWER SUPPLY 
 
IMPORTANT! 
The mains power adaptor must be installed near the equipment and must be easily 
accessible. Power must be turned on at all times for the phone to work 
 
1.  Connect the output plug of the mains adaptor to the adaptor socket on the back of 
the base unit and the mains adaptor to the wall mains supply. 
2.  Connect the telephone lead to the phone cord socket on the back of the base unit 
and to the wall phone socket. 
 
FITTING BATTERIES 
 
IMPORTANT:  Only use the rechargeable batteries provided with this phone. 
 
1. Place your handset with the keypad facing downwards. 
2. Remove the battery compartment cover by pushing on the indent and sliding it in 
your direction. 
3. Insert the two batteries (AAA) into the battery compartment, observing the correct 
polarity. 
4. Slide the battery compartment cover gently back into place, it will click when it is in 
the correct position. 
 
IMPORTANT! 
PLACE THE HANDSET IN THE BASE UNIT AND LEAVE FOR 15 HOURS TO 
CHARGE THE BATTERIES FULLY BEFORE FIRST USE. 
 
RECHARGING YOUR CORDLESS PHONE 
When your handset battery becomes low the Low Battery symbol 
appears on the 
display.  To recharge it, just replace the handset on the base unit. 
 
Tip! It is good practice to put the handset on the base unit to charge when it is 
not in use or every evening to ensure the handset is always fully charged 
 
 REPLACING BATTERIES 
 
 CAUTION  
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN 
INCORRECT TYPE.  Never use non-rechargeable batteries; use only type 
supplied with this telephone.  Ni-MH batteries must be disposed of in 
accordance with the applicable waste disposal regulations. 
When the handset 
needs to be charged more frequently, even when batteries are correctly recharged, it is 
time to replace the batteries: follow the instruction above “Fitting Batteries”.