GE spacemaker wsm2400l User Manual

● 

Wipe 

 cabinet with a damp

cloth. Occasionally wash it with
mild soap and water and then apply
a light coat of appliance polish to
help preserve the finish.

● 

Keep the area around and

underneath your appliance free from
the accumulation of combustible
materials such as lint, paper, rags,
chemicals, etc.

 Keep the floor around your

appliance clean and dry to reduce
the possibility of slipping.

● 

For long vacations,  be sure

water supply is shut off at faucets.
Drain all water from hoses if the
appliance will be exposed to
freezing weather.

● 

The washer cannot be operated in
freezing temperatures. Before you

store the appliance, remove water
from all parts of the washer.

1. Turn off water supply faucets.

(The front access panel between
washer and dryer may have to be
removed. See procedure at right. )
Disconnect hoses from faucets
and drain.

2. Add 1 gallon of non-toxic 
antifreeze (available from the
hardware or recreational vehicle
store) to the washer tub.

3. Push the timer knob in, turn the
knob to the right to SPIN and pull

the knob out.

4. Let the washer spin for   or 2

minutes to let all water drain out.
Some but not all of the 
antifreeze will be expelled.

5. Push in the timer knob, dry
the tub interior, disconnect the
electrical plug, close the lid.

6. Store the appliance in an upright
position.

7. Before reusing washer, after
storage, run washer through a cycle
to rinse out the antifreeze.

● 

 The self-cleaning lint

filter needs no attention from you.

● 

leave the lid open to allow moisture

to evaporate. Clean thoroughly with
nonabrasive household cleanser to

remove deposit left by heavily soiled

clothes. Do not use harsh cleansers.

 Agitator. Remove the agitator at

regular intervals—about 4 to 6
months—and remove any lint that
may have accumulated. After

removing the front access panel, as
shown at right, unscrew the agitator
cap, grasp the agitator with both
hands, and pull it up and out of the

The slotted section at the top of the
metal shaft has a light coating of
lubricant to prevent parts from
sticking together. If this area appears
to be dry, apply a 

 coat of

grease or petroleum jelly around
the shaft before replacing the
agitator. Do not 

 Excess

grease may get into the clothes 

When replacing the agitator,
carefully lower it straight down
onto the agitator support block and
replace the cap securely.

If your dryer is exhausted to the
outside, inspect and clean the dryer
exhaust 

 at least once a

year.

A clothes dryer produces combustible
lint. When the dryer is not exhausted

to the outside, this lint is more apt
to accumulate in and near the dryer,
which could create a fire hazard.

25

. Clean the lint filter before every

load. See page 7.

● 

Inspect the area behind the front

access 

 at least once a year

and clean out any lint that may have
accumulated. Wipe or 

 being

careful not to disturb any electrical
or mechanical connections.

Take out 2 screws holding the
magnet assembly and remove
the magnet assembly.

Then take out 2 screws at top
corners of access panel and lift
access panel up until tabs at 
of panel slip out of slots at rear of
washer.

The washer lid can now be 
enough to allow you to remove 
agitator, and the dryer exhaust

 is accessible for 

and cleaning.

To replace the front access panel,
fit tabs on panel into slots at rear 
washer, push panel back in place
and replace screws and magnet
assembly.