GE spacemaker wsm2400l User Manual

Page of 28
 to operate your clothes washer
 reduce the risk of fire, electric 
shock, or injury to persons,
read the IMPORTANT 
 INSTRUCTIONS before operating this appliance.
 the washer properly
● 
Add accurately-measured
detergent to empty tub. See  pages
11 through 13.
● 
Load clothes loosely.  Dry clothes
level should be no higher than the
top row of circular holes in the wash
tub. Do not put clothes on top of the
agitator or wind them around it.
For best results, mix large items
with small ones. When washing a
single heavy item, such as a shag
rug or bedspread, add one or two
other pieces to balance the load.
Large items should be no more
than one-half of the total load.
Here is a typical 
 load:
double sheets 2 long-sleeve
2 pair trousers
shirts
2 standard
pillowcases
To bleach the load, measure
liquid bleach according to directions
on container. After washer has 
and agitated for several minutes, add
diluted bleach to the wash water.
How to use powdered bleach,
fabric softeners and other laundry
products is explained on page 15.
● 
Close lid.  Washer will fill and
agitate but will not spin with lid
open. This washer has a Safety Lid
Lock. As a safety measure the lid
will be automatically locked during
the spin portion of each cycle. The
lid will automatically unlock about
30 seconds after the end of the spin
cycle. To open lid during spin cycle,
push Cycle Selector IN and wait for
lid lock to release, about 30 seconds,
before opening.
For your personal safety, never
reach into washer while parts are
moving. 
Always stop washer to
load, unload, add forgotten items
or additional laundry aids.
 
Set the controls
See the Controls Setting Guide on
@Push Cycle Selector in and
pages 8 and 9.
turn clockwise to your selected
 Washing Temperature.
wash cycle.
Cold rinse will be automatically
 
 start
provided with all cycles.
the cycle.
 Water Level.
Note: If you have selected the 
Press or Regular cycle and wish to
SMALL: Washer is less than 1/3
change cycle setting after washer
 of clothes.
has started, push 
 Selector in
MEDIUM: Between 1/3 and 2/3 full.
and wait for washer to stop. Then
LARGE: Over 2/3 full of clothes.
reset to the new position. Setting
can be changed at any time during
the 
 
 or Regular cycle 
Self-cleaning lint filter.  The lint
filter needs no attention from you.
Lint collected during washing and
rinsing of clothes is automatically
flushed down the drain.
How to soak in the washer
Set Washing Temperature control.
Add detergent or soak agent. Turn
Cycle Selector to desired cycle.
Start the washer. After washer fills
and begins to agitate, push in the
Cycle Selector to stop washer. Allow
to soak for as long as desired. After
desired soak, turn to the last Spin.
Pull out the Cycle Selector to
complete the cycle.
Delicate cycle
 STAR
USH STOP
o
 
/. .$’:
 -
To get the full benefit of the
Delicate Cycle, always set it at
the beginning of the cycle. During
wash, the Delicate Cycle alternates
between agitation and pauses to
protect delicate clothes.
6
—...