GPX X642 User Manual

The following are special conditions for the Facsimile User Instructions.

The grant of a telepermit for any item of terminal equipment indicates only that Telecom has 
accepted that the item complies with minimum conditions for connection to its network. It indicates no 
endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it 
provides no assurance that any item will work correctly in all respects with another item of 
telepermitted equipment of a different make or model, nor does it imply that any product is 
compatible with all of Telecom's network services.

This equipment shall not be set up to make automatic calls to the Telecom's 111 Emergency Service.

This equipment may not provide for the effective hand-over of a call to another device connected to 
the same line.

This equipment should not be used under any circumstances that may constitute a nuisance to other 
Telecom customers.

Some parameters required for compliance with Telecom's telepermit requirements are dependent on 
the equipment associated with this device. The associated equipment shall be set to operate within 
the following limits for compliance to Telecom's specifications:

There shall be no more than 10 call attempts to the same number within any 30 minute period 
for any single manual call initiation, and

The equipment shall go on-hook for a period of not less than 30 seconds between the end of 
one attempt and the beginning of the next call attempt.

The equipment shall be set to ensure that automatic calls to different numbers are spaced 
such that there is not less than 5 seconds between the end of one call attempt and the 
beginning of another.

This modem must be used in conjunction with an approved surge protection device when connected 
to the PSTN.

This product requires a German billing tone filter (Lexmark part number 14B5123) to be installed on 
any line which receives metering pulses in Germany. Metering pulses may or may not be present on 
analog lines in Germany. The subscriber may request that metering pulses be placed on the line, or 
can have them removed by calling the German network provider. Normally, metering pulses are not 
provided unless specifically requested by the subscriber at the time of installation.

This product requires a Swiss billing tone filter (Lexmark part number 14B5109) to be installed on 
any line which receives metering pulses in Switzerland. The Lexmark filter must be used, as 
metering pulses are present on all analog telephone lines in Switzerland.